2000 Mazda MX-5

Exhaust carbon monoxide content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Exhaust carbon monoxide content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Suspension arm corroded but not seriously weakened All (5.3.3 (b) (i))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust carbon monoxide content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Nearside Parking brake inoperative on one side (1.4.1 (a))

Offside Parking brake inoperative on one side (1.4.1 (a))

Offside Rear Service brake excessively binding (1.2.1 (f))

Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) DANGEROUS

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Rear Service brake binding but not excessively (1.2.1 (f))

Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Suspension arm corroded but not seriously weakened All (5.3.3 (b) (i))

Nearside Rear Non obligatory reverse lamp inoperative

Offside Front Brake pipe corroded, covered in grease or other material Corroding (1.1.11 (c))

Offside Rear Outer Integral body structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security Sill (6.2.2 (d) (i))

Widespread surface corrosion across underbody

Hazard warning switch inoperative (4.4.2 (a) (ii))

Nearside Rear Non obligatory reverse lamp inoperative

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Integral body structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security (6.2.2 (d) (i))

Widespread corrosion across underbody

Hazard warning switch faulty (4.4.2 (a) (i))

Rear registration plate deteriorated but not likely to be misread (6.3.1d)

Exhaust has a minor leak of exhaust gases (7.1.2)

Nearside Front position lamp(s) not working (1.1.A.3b)

Offside Rear fog lamp not working (1.3.2b)

Exhaust has a minor leak of exhaust gases (7.1.2)

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Offside Front Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Inner Front Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Front Brake pad(s) wearing thin (3.5.1g)

Nearside Headlamp not working on dipped beam (1.7.5a)

Nearside Rear Brake pipe excessively corroded (3.6.B.2c)

Nearside Rear Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Offside Rear Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Rear Brake pipe slightly corroded (3.6.B.2c)

Rear Brake pad(s) wearing thin (3.5.1g)

Rear Brake pad(s) wearing thin (3.5.1g)

Front Brake pad(s) wearing thin (3.5.1g)

Rear Brake pad(s) wearing thin (3.5.1g)