2000 Toyota Yaris

Exhaust emissions carbon monoxide content at idle excessive (7.3.D.4)

Headlamp aim beam image obviously incorrect (1.8.A.1b)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Rear Suspension component mounting prescribed area is excessively corroded inner wing/sill end (2.4.A.3)

Nearside Rear Suspension component mounting prescribed area is excessively corroded lower inner sill (2.4.A.3)

Nearside Rear Suspension component mounting prescribed area is excessively corroded outer sill (2.4.A.3)

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Headlamp excessively deteriorated so that the light output is severely reduced (1.7.5a)

Offside Rear Suspension component mounting prescribed area is excessively corroded inner wing/sill end (2.4.A.3)

Offside Rear Suspension component mounting prescribed area is excessively corroded lower inner sill (2.4.A.3)

Offside Windscreen wiper does not clear the windscreen effectively (8.2.2)

At the time of test the engine management light was on

Nearside Front Outer Anti-roll bar rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Rear coil spring corroded (2.4.C.1b)

Offside Front Outer Anti-roll bar rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive outer sill (2.4.A.3)

Offside Rear coil spring corroded (2.4.C.1b)

Rear Exhaust has a minor leak of exhaust gases (7.1.2)

Both front tyres are on the legal tread depth limits

Both rear lower inner sills are heavily corroded

Both rear suspension coil springs are corroded

Despite poor running and the engine management light on the vehicle just passed its cat test

Oil leak ()

Oil leak gearbox ()

The fuel filler neck is corroded

The offside headlamp lens as opaque and the beam pattern and light output is only just acceptable

At the time of test the engine management light was on

Front Brake pad(s) wearing thin (3.5.1g)

Nearside Front Outer Anti-roll bar rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Outer Anti-roll bar rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

The offside headlamp lens is opaque but the beam pattern and light output is acceptable

The rear axle beam has a large dent nearside at the top

The rear exhaust joint is heavily corroded and blowing

At the time of test the engine management light was on

Centre Stop lamp not working (1.2.1b)

Front Brake pad(s) wearing thin (3.5.1g)

Nearside Front Outer Anti-roll bar rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Outer Anti-roll bar rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front position lamp(s) not working (1.1.A.3b)

The offside headlamp lens is opaque but the beam pattern and light output is acceptable

The rear axle beam has a large dent nearside at the top

The rear exhaust joint is heavily corroded and blowing

At the time of test the engine management light was on

Both front outer anti-rollbar mounts are in poor condition

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Nearside Registration plate lamp not working (1.1.C.1d)

Offside Headlamp aim beam image obviously incorrect (1.8.A.1b)

At the time of test the engine management light was on

Both front outer anti-rollbar mounts are in poor condition

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Front registration plate deteriorated but not likely to be misread (6.3.1d)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Front Suspension arm ball joint dust cover deteriorated, but preventing the ingress of dirt (2.4.G.2)

Nearside Front Brake hose excessively deteriorated (3.6.B.4d)

Nearside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Front registration plate deteriorated but not likely to be misread (6.3.1d)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Front Suspension arm ball joint dust cover deteriorated, but preventing the ingress of dirt (2.4.G.2)

Child seat fitted not allowing full inspection of adult belt

Nearside Rear Tyre has a bulge, caused by separation or partial failure of its structure (4.1.D.1b)

Child seat fitted not allowing full inspection of adult belt

offside rear tyre sidewall fatigue