2006 Aprilia RX50

Drive chain worn but not considered excessive (6.2.1e)

Exhaust noisy (7.1.2)

Front Wheel damaged but not significantly reducing the original strength (4.2.1a)

Rear wheel bearings have slight free play (2.4.A.2c)

front sprocket guard missing

handle bar grip worn

Direction indicator not working (1.5.1c)

Front position lamp does not illuminate immediately when switched on (1.1.3a)

Headlamp aim not tested (1.6)

Headlamp at least one does not illuminate on dipped beam (1.2.2a(i))

Headlamp at least one does not illuminate on main beam (1.2.2a(ii))

Horn not working (1.7.3a)

Indicator tell tale not functioning (1.5.2)

Locking device(s) not correctly fitted which may make the motor bicycle dangerous to ride (6.2.1h)

Rear position lamp does not illuminate immediately when it is switched on (1.1.3a)

Stop lamp does not illuminate immediately a brake applies (1.3.1a)

Drive chain worn but not considered excessive (6.2.1e)

Exhaust noisy (7.1.2)

Front Wheel damaged but not significantly reducing the original strength (4.2.1a)

Rear wheel bearings have slight free play (2.4.A.2c)

Roller brake test Higher brake efficiency normally obtainable. (3.3.A2b)

handle bar grip worn

Rear Rear wheel bearings have excessive free play (2.4.A.2c)

Front Tyre worn close to the legal limit (4.1.3(ii))

Front Wheel has a slightly distorted bead rim. (4.2.2)

exhaust loose

Brake lever is bent and the brake cannot be readily applied (3.1.3c)

Brake pedal is bent and the brake cannot be readily applied (3.1.3c)

Front Brake pad(s) less than 1.5 mm thick (3.2.A1f(i))

Front Headlamp at least one does not illuminate on dipped beam (1.2.2a(i))

Front Stop lamp does not illuminate immediately a brake applies (1.3.1a)

Front position lamp incorrect colour (1.1.2a)

Nearside Rear Footrest missing (6.2.1a)

Offside Rear Footrest missing (6.2.1a)

Position lamp switch faulty (1.1.4a)

Roller brake test The less effective brake control does not achieve an efficiency of 25%. (3.3.A2b)

Front Tyre worn close to the legal limit (4.1.3(ii))

Front Wheel has a slightly distorted bead rim. (4.2.2)

exhaust loose

Rear Brake pad(s) (sintered type) less than 1.0mm thick (3.2A1f(ii))