2006 Chevrolet Matiz

Exhaust carbon monoxide content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Exhaust carbon monoxide content at idle exceeds default limits (8.2.1.2 (b))

Nearside Front Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Nearside Front Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Middle inner sill (5.3.6 (a) (i))

Offside Front Suspension arm ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Brake pipe corroded, covered in grease or other material Both rear (1.1.11 (c))

Nearside Front Brake hose has slight corrosion to ferrule (1.1.12 (f) (i))

Nearside Front Macpherson strut corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive Inner sill (5.3.6 (a) (i))

Nearside Rear Wheel bearing has slight play (5.1.3 (a) (i))

Offside Front Brake hose has slight corrosion to ferrule (1.1.12 (f) (i))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive Inner sill (5.3.6 (a) (i))

Suspension arm corroded but not seriously weakened Both front (5.3.3 (b) (i))

Nearside Front Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Nearside Front Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Nearside Rear Brake pipe excessively corroded (1.1.11 (c))

Nearside Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill (5.3.6 (a) (i))

Offside Front Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Rear Brake pipe excessively corroded (1.1.11 (c))

Offside Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill (5.3.6 (a) (i))

Suspension component mounting prescribed area is corroded but not considered excessive both side rear inner sills & axle (5.3.6 (a) (i))

Axle swivel pins and bushes swivel pin and/or bush slightly worn rear axle bushes perishied and splitting (5.1.2 (b) (i))

Nearside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Nearside Rear Wheel bearing has excessive play (5.1.3 (a) (i))

Offside Front Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Offside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Axle swivel pins and bushes swivel pin and/or bush slightly worn rear axle bushes perishied and splitting (5.1.2 (b) (i))

Nearside Front Wheel bearing has slight play (5.1.3 (a) (i))

Nearside Rear nail in tyre

Nearside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Rear Brake pipe excessively corroded (1.1.11 (c))

Offside Rear Direction indicator incorrect colour (4.4.3 (a))

Offside Outer Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Front passenger door cannot be opened from outside the vehicle (6.2.3 (a))

Main beam tell-tale not working (4.9.1 (a) (ii))

Offside Front Lower Seat belt anchorage prescribed area strength or continuity significantly reduced Corrosion to center sill area. (7.1.1 (a) (i))

Offside Front Lower Suspension spring mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

Head lamps dull.

Offside Outer Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Nearside Front Windscreen wiper does not clear the windscreen effectively Spring in arm weak, not allowing enough pressure on blade. (3.4 (b) (ii))

Rear Wheel bearing has slight play both (5.1.3 (a) (i))

both front shock absorbers corroded

Nearside Brake pipe excessively corroded front to rear (1.1.11 (c))

Nearside Rear Upper Shock absorbers has an excessively worn bush (5.3.2 (c))

Front Brake disc in such a condition that it is seriously weakened (1.1.14 (a) (ii)) DANGEROUS

Offside Rear Upper Shock absorbers has a slightly worn bush (5.3.2 (c))

Rear Wheel bearing has slight play both (5.1.3 (a) (i))

both front shock absorbers corroded

Nearside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Macpherson strut corroded but not seriously weakened (5.3.3 (b) (i))

Offside Front Seat belt anchorage prescribed area strength or continuity significantly reduced (7.1.1 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Nearside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Headlamp aim too high (4.1.2 (a))

Offside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Macpherson strut corroded but not seriously weakened (5.3.3 (b) (i))

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Headlamp aim beam image obviously incorrect (1.8.A.1b)

Offside Front Suspension arm locating pin retaining device missing (2.4.G.3b)

Front Brake pad(s) wearing thin (3.5.1g)

Nearside Track rod end ball joint dust cover deteriorated, but preventing the ingress of dirt (2.2.C.1c)

Offside Rear Brake pipe slightly corroded (3.6.B.2c)

Offside Track rod end ball joint dust cover deteriorated, but preventing the ingress of dirt (2.2.C.1c)

Offside Front Lower Suspension arm has excessive play in a ball joint (2.4.G.2)

Offside Front position lamp(s) not working (1.1.A.3b)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Brakes imbalanced across an axle (3.7.B.5b)

Offside Rear Rear position lamp(s) adversely affected by the operation of another lamp (1.1.A.3f)

according to the colour of the front brake discs it appears that brakes may not have been releasing although no evidence of binding was found on test

Offside Front Tyre worn close to the legal limit (4.1.E.1)