2007 Piaggio Porter

Battery insecure and likely to fall from carrier (4.13 (a) (ii))

Front Dipswitch operation does not deflect all main beam headlamps to make them dipped beams (4.1.3 (b))

Front Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced cross member, around the radiator (6.1.1 (c) (i))

Nearside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength wheel arch (5.3.6 (a) (i))

Nearside Front Windscreen wiper missing (3.4 (a))

Nearside Other passenger door cannot be opened from outside the vehicle (6.2.3 (a))

Nearside Service brake effort inadequate at a wheel (1.2.1 (a) (i))

Offside Front Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Offside Front Outer Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength wheel arch (5.3.6 (a) (i))

Offside Front Windscreen wiper missing (3.4 (a))

Offside Other passenger door cannot be opened from outside the vehicle (6.2.3 (a))

Offside Service brake effort inadequate at a wheel (1.2.1 (a) (i))

Service brake efficiency below requirements (1.2.2 (a) (i))

Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced under-body battery carriage (6.1.1 (c) (i))

Vehicle structure is fractured and structural rigidity is significantly reduced (6.1.1 (a) (i))

Nearside Rear reflector defective or damaged by up to 50% of the reflecting surface (4.8.1 (a) (i))

Central Exhaust has a major leak of exhaust gases (6.1.2 (a))

Emissions not tested (8.2.1.2 (d))

Nearside Rear Rear reflector missing (4.8.2 (a) (ii))

Nearside Rear Service brake effort inadequate at a wheel (1.2.1 (a) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength spring mount front (5.3.6 (a) (i))

Offside Rear Service brake effort inadequate at a wheel (1.2.1 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength spring mount front (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength spring mount rear (5.3.6 (a) (i))

Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Service brake efficiency below requirements (1.2.2 (a) (i))

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Front registration plate deteriorated (6.3.1d)

Nearside Front position lamp(s) not working (1.1.A.3b)

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear Brake pipe excessively corroded (3.6.B.2c)

Offside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Rear Exhaust has a major leak of exhaust gases (7.1.2)

Service brake: efficiency below requirements (3.7.B.7)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

rear exhaust rusted

Brake fluid warning lamp illuminated (3.6.G.2)

Braking system leaking load compensater (3.6.A.1)

Nearside rear brake recording little or no effort (3.7.B.5a)

Offside Rear Suspension component mounting prescribed area is excessively corroded undersill (2.4.A.3)

Offside rear brake recording little or no effort (3.7.B.5a)

Service brake: efficiency below requirements (3.7.B.7)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

rear exhaust rusted

EXAUST TAIL PIPE CORRODED

Front Brake hose has slight corrosion to ferrules BOTH SIDES MIDDLE FERRULES (3.6.B.4e)

Front Macpherson strut corroded but not seriously weakened BOTH SIDES LOWER CUPS STARTING TO CORRODED (2.4.G.1)

Offside Leaf spring shackle bracket corroded but not seriously weakened (2.4.B.6d)

Offside REAR INNER SILL AT SLIDING DOOR RUSTED.

Nearside Headlamp does not operate immediately when selected on dipped beam (1.7.4a)

Nearside Headlamp not working on dipped beam (1.7.5a)

Offside Headlamp not working on dipped beam (1.7.5a)

Offside Headlamp not working on main beam (1.7.5a)

Rear Brakes imbalanced across an axle Axle 2 (3.7.B.5b)

Service brake: efficiency below requirements (3.7.B.7)

EXAUST TAIL PIPE CORRODED

Front Brake hose has slight corrosion to ferrules BOTH SIDES MIDDLE FERRULES (3.6.B.4e)

Front Macpherson strut corroded but not seriously weakened BOTH SIDES LOWER CUPS STARTING TO CORRODED (2.4.G.1)

Offside Leaf spring shackle bracket corroded but not seriously weakened (2.4.B.6d)

Offside REAR INNER SILL AT SLIDING DOOR RUSTED.

Brakes imbalanced across an axle (3.7.B.5b)

Parking brake: efficiency below requirements (3.7.B.7)

Service brake: efficiency below requirements (3.7.B.7)

Brakes imbalanced across an axle (3.7.B.5b)

Offside rear brake recording little or no effort (3.7.B.5a)

Service brake: efficiency below requirements (3.7.B.7)

Nearside Front Brake hose has slight corrosion to ferrules (3.6.B.4e)

Offside Front Brake hose has slight corrosion to ferrules (3.6.B.4e)

Offside Rear Lower Brake pipe slightly corroded (3.6.B.2c)

Rear Brake hose has slight corrosion to ferrules (3.6.B.4e)

Rear Brake pipe excessively corroded (3.6.B.2c)

Nearside Front Brake hose has slight corrosion to ferrules (3.6.B.4e)

Offside Front Brake hose has slight corrosion to ferrules (3.6.B.4e)

Offside Rear Lower Brake pipe slightly corroded (3.6.B.2c)

Rear Brake hose has slight corrosion to ferrules (3.6.B.4e)

Nearside Front wheel bearing has slight play (2.5.A.3c)