MOT Status
ValidMileage
85,203 miSignificantly above average — investigate
Not all car check providers offer a guarantee. Don't risk buying from services that can't back their data. CarVerify reports include a £30,000 finance data guarantee.
Vehicle Details
All premium checks include
50+ data pointsMOT History
Offside Front Lower Suspension arm ball joint excessively worn (5.3.4 (a) (i))
Offside Rear Hydraulic brake cylinder leaking hydraulic fluid (1.1.16 (b) (i))
Offside Front Lower Suspension arm ball joint has slight play (5.3.4 (a) (i))
Offside front lower suspension arm has very slight play in a balljoint
Front Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii))
Windscreen washer jets misaligned and not providing sufficient fluid to the windscreen (3.5 (a))
How Reliable is the Proton GEN-2?
Based on 59,272 MOT tests across 4,783 vehicles.
Top MOT Failure Points
Don't risk it. Know before you buy.
Not all vehicle check providers are the same. Some don't offer a data guarantee, which means if their information is wrong, you're on your own. Every CarVerify report is backed by a £30,000 finance data guarantee.
WA60 CNC is a 2010 Proton GEN-2 in Silver with a 1,597cc petrol engine. This vehicle has been through 17 MOT tests with a personal pass rate of 82.4%.
Across all 2010 Proton GEN-2 models, the average MOT pass rate is 70.7% with a typical mileage of 48,142 miles. This particular vehicle has performed better than the average for its year.
The most common reason a Proton GEN-2 fails its MOT is tyre tread depth below requirements of 1.6mm, accounting for 2,238 recorded failures. If you're considering buying WA60 CNC, it's worth having these areas checked by a mechanic before committing.
The Proton GEN-2 typically stays on UK roads for around 22 years. At 16 years old, this Proton GEN-2 is well into its expected lifespan but still has years ahead.
Frequently Asked Questions
How do I check the history of WA60 CNC?
You can check the full history of WA60 CNC by running a full vehicle check. This shows you finance, stolen, write-off, MOT history, mileage records and more.
What year was WA60 CNC registered?
WA60 CNC is a 2010 Proton GEN-2, first registered on 3 September 2010.
Is WA60 CNC safe to buy?
The MOT history for WA60 CNC shows 17 tests with a 82.4% pass rate. To check for outstanding finance, stolen markers, write-off history and mileage discrepancies, run a full vehicle check.
Does WA60 CNC have outstanding finance?
Finance checks require a premium vehicle report. This checks against all major UK finance providers to see if there is any outstanding finance on WA60 CNC. If you buy a car with outstanding finance, the finance company can repossess it.
No warranty or guarantee of accuracy is provided for any free data on this page. The data guarantee applies only to information obtained through the purchase of a full check.