2003 Kia Sorento

Front Power steering pipe/hose slightly corroded (2.1.5 (g) (i))

Front Registration plate deteriorated but not likely to be misread is cracked (0.1 (b))

Front both front tyres are worn on inner edges

Nearside Front Outer Brake pad(s) wearing thin very low (1.1.13 (a) (ii))

Nearside Front Seat belt anchorage prescribed area is corroded but not considered excessive inner sill (7.1.1 (a) (i))

Nearside Front inner sill corroded and holed near chassis to body mounting

Nearside Rear Suspension component mounting repair covered in underseal chassis tie bar welded patch is not fully welded along upper edge (5.3.6 (a) (i))

Nearside Rear Suspension component mounting repair covered in underseal inner sill (5.3.6 (a) (i))

Offside Front Seat belt anchorage prescribed area is corroded but not considered excessive inner sill (7.1.1 (a) (i))

Offside Rear Inner Suspension component mounting repair covered in underseal inner sill welded patch is hard to see if its fully welded to the outer sill. (5.3.6 (a) (i))

Rear Fuel Pipe/s corroded ()

Rear Oil leak, but not excessive diff oil leak (8.4.1 (a) (i))

long travel and free play on hand brake lever

Offside Rear Inner Suspension component mounting prescribed area is inadequately repaired inner sill welded patch is not fully welded to the outer sill along lower edge (5.3.6 (a) (i))

Front Power steering pipe/hose slightly corroded (2.1.5 (g) (i))

Front Registration plate deteriorated but not likely to be misread is cracked (0.1 (b))

Front both front tyres are worn on inner edges

Nearside Front Outer Brake pad(s) wearing thin very low (1.1.13 (a) (ii))

Nearside Front Seat belt anchorage prescribed area is corroded but not considered excessive inner sill (7.1.1 (a) (i))

Nearside Front inner sill corroded and holed near chassis to body mounting

Nearside Rear Suspension component mounting repair covered in underseal chassis tie bar welded patch is not fully welded along upper edge (5.3.6 (a) (i))

Nearside Rear Suspension component mounting repair covered in underseal inner sill (5.3.6 (a) (i))

Offside Front Seat belt anchorage prescribed area is corroded but not considered excessive inner sill (7.1.1 (a) (i))

Rear Fuel Pipe/s corroded ()

Rear Oil leak, but not excessive diff oil leak (8.4.1 (a) (i))

long travel and free play on hand brake lever

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength rear axle diff stabiliser mount corroded & holed (5.3.6 (a) (i))

Offside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Inner sill (5.3.6 (a) (i))

Front Power steering pipe/hose slightly corroded rack to rack pipes corroded (2.1.5 (g) (i))

Front Registration plate deteriorated but not likely to be misread Damaged & cracked (0.1 (b))

Handbrake has little reserve travel

Nearside Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Front Upper Suspension arm pin or bush worn but not resulting in excessive movement Rear arm rear bush (5.3.4 (a) (i))

Rear Fuel Pipe/s corroded ()

Rear Oil leak, but not excessive Diff leak (8.4.1 (a) (i))

Central Front Windscreen washer provides insufficient washer liquid (3.5 (a))

Nearside Front Inner Seat belt anchorage prescribed area strength or continuity significantly reduced Inner sill corroded & holed (7.1.1 (a) (i))

Nearside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Inner sill (5.3.6 (a) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength rear axle diff stabiliser mount corroded & holed (5.3.6 (a) (i))

Offside Front Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Front Inner Seat belt anchorage prescribed area strength or continuity significantly reduced Inner sill corroded & holed (7.1.1 (a) (i))

Offside Rear Anti-roll bar pin or bush excessively worn (5.3.4 (a) (i))

Offside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Inner sill (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Track control arm mounting corroded & holed (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength rear axle diff stabiliser mount corroded & holed (5.3.6 (a) (i))

Front Power steering pipe/hose slightly corroded rack to rack pipes corroded (2.1.5 (g) (i))

Front Registration plate deteriorated but not likely to be misread Damaged & cracked (0.1 (b))

Handbrake has little reserve travel

Nearside Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Front Upper Suspension arm pin or bush worn but not resulting in excessive movement Rear arm rear bush (5.3.4 (a) (i))

Rear Fuel Pipe/s corroded ()

Rear Oil leak, but not excessive Diff leak (8.4.1 (a) (i))

Nearside Rear Fuel pipe leaking (6.1.3 (b) (i))

Offside Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Rear Exhaust has a major leak of exhaust gases joint centre/rear pipe corroded (7.1.2)

sill covers present

Nearside Front Anti-roll bar linkage has excessive play in a pin/bush (2.4.G.2)

Nearside Front Suspension component mounting prescribed area is excessively corroded inner sill (2.4.A.3)

Nearside Headlamp aim not tested (1.8.A.1c)

Nearside Headlamp not working on dipped beam (1.7.5a)

Nearside Rear Suspension component mounting prescribed area is excessively corroded inner sill (2.4.A.3)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Suspension component mounting prescribed area is excessively corroded inner sill (2.4.A.3)

Offside Rear Shock absorber has a serious fluid leak (2.7.3)

Offside Rear Suspension component mounting prescribed area is excessively corroded inner sill (2.4.A.3)

Offside Rear Suspension component mounting prescribed area is excessively corroded outer sill under plastic trim (2.4.A.3)

Front tyres worn on inner edge

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Rear Brake pad(s) wearing thin (3.5.1g)

sill covers present

slight bind on o/s/r brake

Nearside Stop lamp not working (1.2.1b)

Offside Front Anti-roll bar linkage rubber mounting deteriorated resulting in excessive movement (2.4.G.2)

Offside Rear Anti-roll bar linkage rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Oil leak

o/s/f inner sill corroded

Nearside Stop lamp not working (1.2.1b)

Offside Stop lamp not working (1.2.1b)

Supplementary Restraint System warning lamp indicates a fault (5.4.2)

Offside Rear Anti-roll bar linkage rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Oil leak

o/s/f inner sill corroded

Offside Front Headlamp has a product on the lens but not seriously reducing light output (1.7.5a)

Offside Front Track rod end ball joint has slight play (2.2.B.1f)

Air bag warning light is on.

Drivers door window does not operate.

Brake relay lever has restricted free movement (3.5.1k)

Nearside Headlamp aim too low (1.8)

Nearside Rear Registration plate lamp not working (1.1.C.1d)

Offside Headlamp aim too low (1.8)

Offside Windscreen washer provides insufficient washer liquid (8.2.3)

Parking brake lever has no reserve travel (3.1.6b)

Power steering pipe(s) or hose(s) leaking (2.3.3b)

Air bag warning light is on.

Drivers door window does not operate.

Centre Exhaust has part of the system slightly deteriorated (7.1.1a)

Nearside Front Brake pipe slightly corroded (3.6.B.2c)

Nearside Rear Anti-roll bar synthetic mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Brake pipe slightly corroded (3.6.B.2c)

Offside Front Headlamp not in a clean condition but not affecting beam image (1.2.4a)

Offside Rear Anti-roll bar synthetic mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Oil leak

Rear Exhaust has part of the system slightly deteriorated (7.1.1a)

fuel pipes corroded

plastic covers fitted

Nearside Front Front wheel bearing has excessive play (2.5.A.3c)

Centre Exhaust has part of the system slightly deteriorated (7.1.1a)

Nearside Front Brake pipe slightly corroded (3.6.B.2c)

Nearside Rear Anti-roll bar synthetic mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Brake pipe slightly corroded (3.6.B.2c)

Offside Front Headlamp not in a clean condition but not affecting beam image (1.2.4a)

Offside Rear Anti-roll bar synthetic mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Oil leak

Rear Exhaust has part of the system slightly deteriorated (7.1.1a)

fuel pipes corroded

plastic covers fitted

front brake pads low

minor oil leak around oil filter

offside front brake pipe corroding

oil leak around pipe from oil cooler

rear anti roll bar nearside inner bush slightly worn

sill covers fitted

Offside Registration plate lamp not working (1.1.C.1d)

front brake pads low

minor oil leak around oil filter

offside front brake pipe corroding

oil leak around pipe from oil cooler

rear anti roll bar nearside inner bush slightly worn

sill covers fitted

Exhaust has part of the system slightly deteriorated (7.1.1a)

Nearside Front Brake pad(s) wearing thin (3.5.1g)

Offside Front Brake pad(s) wearing thin (3.5.1g)

Exhaust has part of the system excessively deteriorated (7.1.1a)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Front Brake pad(s) wearing thin (3.5.1g)

Offside Front Brake pad(s) wearing thin (3.5.1g)

damage to nearside front buper

small stone chips on screen