2016 Lexmoto Xflm

Chain guard missing ()

Drive chain slightly tight (6.1.7 (k) (i))

Exhaust noisy (8.1.1 (a))

Front Brake binding but not excessively (1.2.1 (f))

Rear Outer Brake pad(s) close to minimum limit (1.1.13 (a))

All position lamps not working (4.2.1 (a))

Drive chain excessively loose (6.1.7 (c) (i))

Drive chain worn to excess (6.1.7 (c) (i))

Headlamp aim not tested (4.1.2 (b))

Headlamp not working on dipped beam (4.1.1 (a) (ii))

Horn not working (7.7 (a))

Position lamp switch does not operate in accordance with the requirements (4.2.2 (a))

Rear Footrest missing (6.2.12 (a))

Rear Lower Suspension component ball joint excessively worn (5.3.4 (a) (i))

Registration plate lamp missing in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Steering operation fouling on the fuel tank or bodywork on full lock (2.1.4 (b))

Throttle operating incorrectly stiff (6.2.7 (a) (i))

Chain guard missing ()

Exhaust noisy (8.1.1 (a))

Horn not working (7.7 (a))

Rear Brake indicates excessive fluctuation of brake effort (1.2.1 (e))

Rear Brake master cylinder insecure (1.1.10 (c))

Rear reflector missing (4.8.2 (a) (ii))

Registration plate does not conform to the specified requirements (0.1 (d))

Steering operation fouling on the fuel tank or bodywork on full lock (2.1.4 (b))

Engine mounting/bracket bracket excessively loose (6.1.8 (a) (ii)) DANGEROUS

Engine mounting/bracket excessively loose (6.1.8 (a) (ii)) DANGEROUS

Nearside Handlebar grip insecure to handlebar (2.2.1 (d) (ii)) DANGEROUS

Rear Brake pad(s) less than 1.0 mm thick (1.1.13 (a)) DANGEROUS

Rear Tyre tread depth is below minimum requirements of 1.0mm (5.2.3 (e)) DANGEROUS

Stop lamp does not illuminate by the operation of both brake controls (4.3.2 (a) (iii)) DANGEROUS

Chain guard missing ()

Front Brake indicates slight fluctuation of brake effort (1.2.1 (e))

Rear Suspension pin, bush or joint worn but not resulting in excessive movement (5.3.4 (a) (i))

bolt missing from speedo drive

Exhaust noisy (8.1.1 (a))

Suspension pin, bush or joint worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Front Direction indicator not working (4.4.1 (a) (ii))

Exhaust noisy (8.1.1 (a))

Suspension pin, bush or joint worn but not resulting in excessive movement (5.3.4 (a) (i))

Drive chain horseshoe locking device incorrectly fitted (6.1.7 (j) (i))

Front Brake disc contaminated (1.1.14 (b))

Front Brake lever is so short that the brake cannot be readily applied (1.1.2 (d))

Handlebar mounting insecure (2.2.1 (a) (i))

Nearside Front Shock absorber has a serious fluid leak (5.3.2 (b))

Offside Rear Direction indicator not working (4.4.1 (a) (ii))

Rear reflector missing (4.8.2 (a) (ii))

Registration plate does not conform to the specified requirements (0.1 (d))

Front Wheel bearing play so excessive it is likely to break up (5.1.3 (a) (ii)) DANGEROUS

Exhaust noisy (8.1.1 (a))

Rear Suspension pin, bush or joint worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Front Shock absorber has a light misting of oil (5.3.2 (b))

Offside Front Shock absorber has a light misting of oil (5.3.2 (b))