MOT Status
ValidMileage
126,080 miSignificantly above average — investigate
Not all car check providers offer a guarantee. Don't risk buying from services that can't back their data. CarVerify reports include a £30,000 finance data guarantee.
Vehicle Details
All premium checks include
50+ data pointsMOT History
Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))
Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))
Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))
Rear Sub-frame corroded but not seriously weakened Axle (5.3.3 (b) (i))
Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))
Exhaust has a major leak of exhaust gases (6.1.2 (a))
Nearside Front Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))
Offside Front Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))
Offside Front Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))
Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))
Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))
Offside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))
Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))
Rear Sub-frame corroded but not seriously weakened Axle (5.3.3 (b) (i))
Front Registration plate deteriorated but not likely to be misread (0.1 (b))
Nearside Obligatory mirror slightly damaged (3.3 (b) (i))
Nearside Rear Suspension arm attachment bracket/mounting corroded but its strength is not seriously reduced Axle mounting (5.3.3 (b) (i))
Offside Front Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))
Offside Rear Suspension arm attachment bracket/mounting corroded but its strength is not seriously reduced Axle mounting (5.3.3 (b) (i))
Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive rear subframe/axle mount (5.3.6 (a) (i))
Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive front subframe/axle mount (5.3.6 (a) (i))
Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))
Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))
Nearside Front Anti-roll bar linkage pin or bush excessively worn (5.3.4 (a) (i))
Nearside Front Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))
Offside Front Anti-roll bar linkage pin or bush excessively worn (5.3.4 (a) (i))
Offside Front Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))
Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive rear subframe/axle mount (5.3.6 (a) (i))
Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive front subframe/axle mount (5.3.6 (a) (i))
Front Registration plate deteriorated but not likely to be misread (0.1 (b))
Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))
Nearside Front Brake disc worn, pitted or scored, but not seriously weakened inner edge (1.1.14 (a) (ii))
Nearside Headlamp has a product on the lens but not seriously reducing light output (4.1.4 (b))
Offside Front Brake disc worn, pitted or scored, but not seriously weakened inner edge (1.1.14 (a) (ii))
Offside Headlamp has a product on the lens but not seriously reducing light output (4.1.4 (b))
Rear axle corroded
Horn not working (7.7 (a))
Offside Rear Service brake excessively binding (1.2.1 (f))
Front Registration plate deteriorated but not likely to be misread (0.1 (b))
Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))
Nearside Front Brake disc worn, pitted or scored, but not seriously weakened inner edge (1.1.14 (a) (ii))
Nearside Headlamp has a product on the lens but not seriously reducing light output (4.1.4 (b))
Offside Front Brake disc worn, pitted or scored, but not seriously weakened inner edge (1.1.14 (a) (ii))
Offside Headlamp has a product on the lens but not seriously reducing light output (4.1.4 (b))
Rear axle corroded
Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))
Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))
Offside Rear Wheel bearing slightly noisy (5.1.3 (b) (i))
Offside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))
Horn not working (7.7 (a))
Supplementary restraint system warning lamp indicates a fault (7.1.6 (a))
Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))
Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))
Offside Rear Wheel bearing slightly noisy (5.1.3 (b) (i))
Offside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))
Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))
Offside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))
Fuel cap/sealing device ineffective (6.1.3 (b) (i))
Nearside Headlamp aim too low (4.1.2 (a))
Offside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))
Offside Headlamp aim too low (4.1.2 (a))
Offside Front Tyre worn close to legal limit/worn on edge on the limit (5.2.3 (e))
temp fuel cap fitted but does provide a air tight seal
Exhaust has a minor leak of exhaust gases (6.1.2 (a))
Exhaust noisy (8.1.1 (a))
Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))
Nearside Front Lower Suspension arm insecurely attached (5.3.3 (a) (i))
Nearside Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))
Offside Brake pipe excessively corroded front to rear (1.1.11 (c))
Offside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))
Offside Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))
Nearside Front Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS
Offside Front Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS
Exhaust has a minor leak of exhaust gases (6.1.2 (a))
Exhaust noisy (8.1.1 (a))
Nearside Front Tyre worn close to the legal limit (4.1.E.1)
Offside Rear Tyre worn close to the legal limit (4.1.E.1)
slight noise from n/s/f wheel bearing
Nearside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords and below legal limit on inner edge (4.1.D.1a)
Nearside Front Tyre worn close to the legal limit (4.1.E.1)
Nearside Front position lamp(s) not working (1.1.A.3b)
Nearside Headlamp aim too high (1.8)
Offside Front position lamp(s) not working (1.1.A.3b)
Offside Rear Tyre worn close to the legal limit (4.1.E.1)
slight noise from n/s/f wheel bearing
Nearside Rear Inner Tyre worn close to the legal limit at 2mm (4.1.E.1)
Offside Rear Tyre worn close to the legal limit at 2mm (4.1.E.1)
Oil leak
Nearside Front Headlamp aim beam image obviously incorrect (1.8.A.1b)
Offside Front Headlamp aim beam image obviously incorrect (1.8.A.1b)
Nearside Rear Inner Tyre worn close to the legal limit at 2mm (4.1.E.1)
Offside Rear Tyre worn close to the legal limit at 2mm (4.1.E.1)
Oil leak
Front Brake pad(s) less than 1.5 mm thick (3.5.1g)
Front brake disc in such a condition that it is seriously weakened (3.5.1i)
Front registration plate insecure (6.3.1b)
How Reliable is the Toyota Aygo?
Based on 3,073,569 MOT tests across 286,185 vehicles.
Top MOT Failure Points
Don't risk it. Know before you buy.
Not all vehicle check providers are the same. Some don't offer a data guarantee, which means if their information is wrong, you're on your own. Every CarVerify report is backed by a £30,000 finance data guarantee.
WD55 HTU is a 2006 Toyota Aygo in Grey with a 998cc petrol engine. This vehicle has been through 29 MOT tests with a personal pass rate of 69%.
Across all 2006 Toyota Aygo models, the average MOT pass rate is 73.6% with a typical mileage of 60,291 miles. This particular vehicle has a lower pass rate than the average for its year, which may indicate maintenance issues worth investigating.
The most common reason a Toyota Aygo fails its MOT is tyre tread depth below requirements of 1.6mm, accounting for 33,372 recorded failures. If you're considering buying WD55 HTU, it's worth having these areas checked by a mechanic before committing.
The Toyota Aygo typically stays on UK roads for around 21 years. At 20 years old, this Toyota Aygo is approaching the upper end of the typical lifespan for this model.
Frequently Asked Questions
How do I check the history of WD55 HTU?
You can check the full history of WD55 HTU by running a full vehicle check. This shows you finance, stolen, write-off, MOT history, mileage records and more.
What year was WD55 HTU registered?
WD55 HTU is a 2006 Toyota Aygo, first registered on 16 January 2006.
Is WD55 HTU safe to buy?
The MOT history for WD55 HTU shows 29 tests with a 69% pass rate. To check for outstanding finance, stolen markers, write-off history and mileage discrepancies, run a full vehicle check.
Does WD55 HTU have outstanding finance?
Finance checks require a premium vehicle report. This checks against all major UK finance providers to see if there is any outstanding finance on WD55 HTU. If you buy a car with outstanding finance, the finance company can repossess it.
No warranty or guarantee of accuracy is provided for any free data on this page. The data guarantee applies only to information obtained through the purchase of a full check.