2002 Mazda MX-5

Horn not working (7.7 (a))

Supplementary restraint system warning lamp indicates a fault (7.1.6 (a))

Emissions unable to be completed (8.2.1.2 (d))

Exhaust catalytic converter obviously defective (8.2.1.1 (a))

Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Offside Parking brake inoperative on one side (1.4.1 (a))

Nearside Rear Anti-roll bar linkage insecure and impairing directional stability (5.3.3 (a) (ii)) DANGEROUS

Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) DANGEROUS

Nearside Front Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Front Inner Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Tyre slightly damaged/cracking or perishing all perishing (5.2.3 (d) (ii))

Emissions not tested (8.2.1.2 (d))

Exhaust has a major leak of exhaust gases front pipe to manifold-nut missing (6.1.2 (a))

Nearside Parking brake inoperative on one side (1.4.1 (a))

Nearside Seat belt buckle not functioning as intended not release under pressure (7.1.2 (d))

Offside Seat belt buckle not functioning as intended not release under pressure (7.1.2 (d))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Nearside Rear Service brake has no recorded effort at a wheel (1.2.1 (a) (ii)) DANGEROUS

Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) DANGEROUS

Front Inner Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Tyre slightly damaged/cracking or perishing all perishing (5.2.3 (d) (ii))

both front chassis legs surface corrosion.

Offside Rear Parking brake inoperative on one side (1.4.1 (a))

Parking brake efficiency below requirements (1.4.2 (a) (i))

both front chassis legs surface corrosion.

Front Power steering pipe/hose slightly corroded (2.1.5 (g) (i))

Handbrake getting near end of its travel.

Nearside Front Chassis leg surface corrosion.

Offside Front Chassis leg surface corrosion

Nearside Front Suspension component mounting prescribed area is corroded but not considered excessive antiroll bar area slight corrosion (5.3.6 (a) (i))

Offside Front Suspension component mounting prescribed area is corroded but not considered excessive antiroll bar area slight corrosion (5.3.6 (a) (i))

Nearside Headlamp aim beam image obviously incorrect (1.8.A.1b)

Offside Headlamp aim too high (1.8)

Offside Registration plate lamp not working (1.1.C.1d)

Nearside Rear Service brake indicates brake bind (3.7.D.2a)

Offside Rear Service brake indicates brake bind (3.7.D.2a)

Nearside Rear Tyre has a tear, caused by separation or partial failure of its structure (4.1.D.1b)

Offside Rear Tyre has a tear, caused by separation or partial failure of its structure (4.1.D.1b)

Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Rear Brake pad(s) wearing thin (3.5.1g)

Offside Rear Brake pad(s) wearing thin (3.5.1g)

two rear tyres slightly perished

Nearside Front Tyre has ply or cords exposed (4.1.D.1b)

Nearside Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Front Tyre has ply or cords exposed (4.1.D.1b)

Offside Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

two rear tyres slightly perished

n/s/f and o/s/f tyres perished

Nearside Rear coil spring cracked (2.4.C.1a)

n/s/f and o/s/f tyres perished

Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

Nearside front brake juddering slightly (3.7.A.2b)