2003 Mazda MX-5

Nearside Front Service brake excessively binding (1.2.1 (f))

Nearside Headlamp aim too low (4.1.2 (a))

Nearside Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting centre inner sill section under passenger seat mounting (6.2.2 (d) (i))

Nearside Rear Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting outer sill (6.2.2 (d) (i))

Offside Front Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting inner sill (6.2.2 (d) (i))

Offside Rear Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting inner wheel arch under top seat belt mounting (6.2.2 (d) (i))

Offside Registration plate lamp likely to become detached (4.7.1 (c) (ii))

Position lamp not working both front (4.2.1 (a) (ii))

Offside Front Outer Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Offside Front Tyre has a tear, caused by separation or partial failure of its structure inner side wall (5.2.3 (d) (ii)) DANGEROUS

Front Brake disc worn, but not excessively (1.1.14 (a) (i))

Nearside Front Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

corrosion on all vehicle underside components

Nearside Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Front Seat belt anchorage prescribed area strength or continuity significantly reduced (7.1.1 (a) (i))

Nearside Rear Service brake excessively binding (1.2.1 (f))

Offside Front Seat belt anchorage prescribed area strength or continuity significantly reduced (7.1.1 (a) (i))

Offside Rear Service brake excessively binding (1.2.1 (f))

Nearside Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Both Rear outer sills are heavily corroded.

General under vehicle corrosion.

Nearside Rear tyre worn on the outer edge.

Nearside Rear tyre worn on the outer edge.

Offside Front Headlamp not working on dipped beam (1.7.5a)

Front brake pads wearing low.

General under vehicle corrosion.

Front brake pads wearing low.

General under vehicle corrosion.

Offside Stop lamp not working (1.2.1b)

surface rusting on all suspension units

child seat fitted to n/s

corrosion not through all skins o/s outer sill

o/s/r coil spring corroding

Nearside Front position lamp(s) not working (1.1.A.3b)

Nearside Windscreen wiper blade insecure (8.2.2)

Offside Front position lamp(s) not working (1.1.A.3b)

Windscreen washer provides insufficient washer liquid (8.2.3)

child seat fitted to n/s

corrosion not through all skins o/s outer sill

o/s/r coil spring corroding

Nearside front brake juddering slightly (3.7.A.2b)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside front brake juddering slightly (3.7.A.2b)

Nearside Outer Rear Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Outer Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Nearside Registration plate lamp not working (1.1.C.1d)

Nearside front brake juddering slightly (3.7.A.2b)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside front brake juddering slightly (3.7.A.2b)

o/s/r tyre low tread(2.5mm)

corrosion evident on n/s/r outersill

rear reg.plate condition getting poor

Nearside Headlamp not working on dipped beam (1.7.5a)

Offside Headlamp aim too low (1.8)

Windscreen washer provides insufficient washer liquid (8.2.3)

rear reg.plate condition getting poor

Front Headlamp aim too low (1.6.D2)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)