2006 Toyota Aygo

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust carbon monoxide content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Offside Headlamp aim too high bulb incorrectly fitted (4.1.2 (a))

Offside Rear Service brake excessively binding (1.2.1 (f))

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Offside Front Headlamp has a product on the lens but not seriously reducing light output lens faded (4.1.4 (b))

Rear Exhaust has a minor leak of exhaust gases joint (6.1.2 (a))

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Rear Service brake binding but not excessively (1.2.1 (f))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Rear Brake pipe corroded, covered in grease or other material all (1.1.11 (c))

emissions co reading fluctuating- passed on 2nd fast idle test.

Nearside Rear Service brake binding but not excessively (1.2.1 (f))

Rear Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. nearside low (1.2.1 (b) (i))

both rear tyres perished

Direction indicators not working (1.4.A.2c)

Hazard warning switch faulty (1.4.B.1d)

Brake pedal spongy (3.3.B.1b)

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Hazard warning switch faulty (1.4.B.1d)

Nearside Front Shock absorber has a serious fluid leak (2.7.3)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Front position lamp(s) not working (1.1.A.3b)

Nearside Headlamp not working on dipped beam (1.7.5a)