2007 Ford Ranger

Nearside Front Rear wheel steering ball joint has slight play Ider (2.1.3 (b) (i))

Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Nearside Front Rear wheel steering ball joint has slight play Ider (2.1.3 (b) (i))

Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Nearside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Front Headlamp has a product on the lens so that the light output is severely reduced (4.1.4 (b))

Nearside Front Headlamp has a product on the lens which changes emitted colour to other than white or yellow (4.1.4 (b))

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Anti-lock braking system warning lamp indicates an ABS fault (1.6 (b))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Exhaust emissions exceed level of metered smoke for a turbo charged engine (8.2.2.2 (b))

Nearside Front Headlamp not working on main beam (4.1.1 (a) (ii))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Offside Rear Position lamp has a product on the lens or light source which shows white light to the rear (4.2.3 (b) (ii))

Offside Rear Stop lamp(s) not working (4.3.1 (a) (ii))

Rear Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Nearside Front Steering box has excessive movement between sector shaft and the drop arm Steering idler (2.1.3 (a) (ii)) DANGEROUS

Offside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Rear Passenger's seat insecure (6.2.6 (a) (ii)) DANGEROUS

Nearside Front Anti-roll bar pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Rear Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Offside Rear Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Offside Rear Upper Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

Offside Front Seat belt slightly damaged (7.1.2 (b) (i))

Offside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Prop shaft joint worn, but not excessively (6.1.7 (c) (i))

Anti-roll bar linkage rubber mounting deteriorated but not resulting in excessive movement both front (2.4.G.2)

Nearside Front Shock absorber has a slightly worn bush bottom bush (2.7.4)

Offside Front Seat belt cut but webbing not significantly weakened (5.2.2a)

Propshaft universal joint worn ()

Offside Front Seat belt cut but webbing not significantly weakened (5.2.2a)

Offside Rear Brake pipe excessively corroded x 2 (3.6.B.2c)

Offside Registration plate lamp not working (1.1.C.1d)

Offside Front Seat belt cut but webbing not significantly weakened (5.2.2a)

Front Windscreen washer provides insufficient washer liquid (8.2.3)

Nearside Inner Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Offside Registration plate lamp not working (1.1.C.1d)

Rear Brake pipe excessively corroded (3.6.B.2c)

Play in prop-shaft centre bearing

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Registration plate lamp not working (1.1.C.1d)

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Offside Registration plate lamp not working (1.1.C.1d)

Offside Stop lamp not working (1.2.1b)

Service brake is causing the vehicle to swerve to the offside (3.7.C.2)

Nearside Rear Shock absorber has a slightly reduced damping effect (2.7.5)

Offside Front Brake pad(s) wearing thin (3.5.1g)

Offside Rear Shock absorber has a slightly reduced damping effect (2.7.5)

Offside Headlamp not working on dipped beam (1.7.5a)

Nearside Front position lamp(s) not working (1.1.A.3b)

Nearside Headlamp aim too high (1.8)

Windscreen washer provides insufficient washer liquid (8.2.3)

Nearside Headlamp aim too high (1.8)

Offside Headlamp aim too high (1.8)