2007 Mazda RX8

Nearside Front Upper Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Outer Vehicle structure is corroded but structural rigidity is not significantly reduced sill (6.1.1 (c) (i))

Offside Front Upper Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Outer Vehicle structure is corroded but structural rigidity is not significantly reduced sill (6.1.1 (c) (i))

Rear Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Battery insecure but not likely to fall from carrier (4.13 (a) (i))

Nearside Rear Anti-roll bar ball joint has slight play (5.3.4 (a) (i))

Offside Rear Anti-roll bar ball joint has slight play (5.3.4 (a) (i))

Exhaust carbon monoxide content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Nearside Front Coil spring fractured or broken (5.3.1 (b) (i))

Offside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (5.2.3 (d) (i))

Offside Rear Coil spring fractured or broken (5.3.1 (b) (i))

Offside Front Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

all rear suspension corroded

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Offside Front Anti-roll bar linkage ball joint excessively worn (5.3.4 (a) (i))

Nearside Front Anti-roll bar linkage ball joint likely to become detached DETATCHED (5.3.4 (a) (ii)) DANGEROUS

all rear suspension corroded

Nearside Windscreen washer provides insufficient washer liquid (8.2.3)

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Offside Rear nail in tyre

oil leak

Nearside Headlamp aim too high (1.8)

Offside Headlamp aim too high (1.8)

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Front registration plate insecure (6.3.1b)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

Rear brake disc excessively pitted (3.5.1h)

Front brake disc slightly pitted (3.5.1h)