2007 Chevrolet Matiz

Brake pipe corroded, covered in grease or other material rears to flexi hoses (1.1.11 (c))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Outer Drive shaft joint worn, but not excessively (6.1.7 (c) (i))

Rear Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. 28 percent. Limit 30. (1.2.1 (b) (i))

Front Brakes imbalanced across an axle 45 percent (1.2.1 (b) (i))

Front passenger door cannot be opened from outside the vehicle (6.2.3 (a))

Headlamp light intensity severely reduced both (4.1.4 (a))

Nearside Parking brake inoperative on one side (1.4.1 (a))

Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner arch (5.3.6 (a) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Brake pipe corroded, covered in grease or other material rears to flexi hoses (1.1.11 (c))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Rear Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. 28 percent. Limit 30. (1.2.1 (b) (i))

Front Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (1.2.1 (b) (i))

Front Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (1.2.1 (b) (i))

Nearside Headlamp aim projected beam image is obviously incorrect lamp incorrectly fitted (4.1.2 (c))

Offside Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

second gear selection dificult

surface corrosion to underside of vehicle

Front passenger door cannot be opened from outside the vehicle (6.2.3 (a))

Offside Front Suspension arm ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Rear Engine mounting damaged or deteriorated resulting in excessive movement (6.1.8 (a) (i))

Offside Front Wheel bearing so rough it is likely to overheat or break up (5.1.3 (b) (ii)) DANGEROUS

near side rear brake hose ferrules corroded

Nearside Front Suspension arm ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.4.G.2)

Nearside Front constant velocity joint gaiter damaged to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Nearside Rear Brake hose ferrule excessively corroded (3.6.B.4e)

Nearside Windscreen washer provides insufficient washer liquid (8.2.3)

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Front constant velocity joint gaiter damaged to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Offside Rear Brake hose ferrule excessively corroded (3.6.B.4e)

Offside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Offside Windscreen washer provides insufficient washer liquid (8.2.3)

Offside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Rear Brake hose has slight corrosion to ferrules (3.6.B.4e)

Nearside Rear Brake hose has slight corrosion to ferrules (3.6.B.4e)

Offside Rear tyre cracked on the sidewall

Nearside Front constant velocity joint gaiter deteriorated, but preventing the ingress of dirt (2.5.C.1a)

Front Brake pad(s) wearing thin (3.5.1g)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Front Shock absorber has a serious fluid leak (2.7.3)

Nearside Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Front Headlamp not working on dipped beam (1.7.5a)

Windscreen washer provides insufficient washer liquid (8.2.3)

Nearside Headlamp not working on dipped beam (1.7.5a)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Offside Front Brake pad(s) less than 1.5 mm thick (3.5.1g)