2008 Toyota Aygo

Front Brake disc worn, but not excessively both sides (1.1.14 (a) (i))

Nearside Front Outer Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Nearside Front Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Front Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Front Inner Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Nearside Front Suspension arm ball joint has slight play (5.3.4 (a) (i))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement Rear bush (5.3.4 (a) (i))

Offside Rear Nail in tyre

Offside Front Suspension arm pin or bush excessively worn Rear bush (5.3.4 (a) (i))

Nearside Front Inner Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Nearside Front Suspension arm ball joint has slight play (5.3.4 (a) (i))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement Rear bush (5.3.4 (a) (i))

Offside Rear Nail in tyre

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Rear Coil spring corroded (5.3.1 (b) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Battery insecure and likely to fall from carrier (4.13 (a) (ii))

Nearside Front Lower Suspension arm ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Rear Position lamp adversely affected by the operation of another lamp (4.2.3 (c))

Windscreen washer provides insufficient washer liquid (3.5 (a))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Rear Coil spring corroded (5.3.1 (b) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Rear Service brake binding but not excessively (1.2.1 (f))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

front bushes perished

Exhaust emissions - engine idle speed too high (8.2.1.2 (e))

Registration plate lamp does not illuminate simultaneously with the position lamps (4.7.2 (a))

Offside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Nearside Front Position lamp not working (4.2.1 (a))

Nearside Rear Service brake excessively binding (1.2.1 (f))

Nearside Rear Stop lamp(s) not working (4.3.1 (a) (ii))

Offside Rear Wheel bearing rough when rotated (5.1.3 (b) (i))

Supplementary restraint system warning lamp indicates a fault air bag (7.1.6 (a))

Rear Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (1.2.1 (b) (i))

nearside front tyre only just legal

offside front tyre inner edge only just legal

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Front brake disc in such a condition that it is seriously weakened (3.5.1i)

Registration plate lamp not working (1.1.C.1d)

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Offside Rear Stop lamp not working (1.2.1b)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)