2001 Toyota Yaris

Front Anti-roll bar linkage pin or bush excessively worn (5.3.4 (a) (i))

Offside Front Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner sill (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner wheel arch (5.3.6 (a) (i))

Rear Sub-frame corroded and seriously weakened nearside (5.3.3 (b) (i))

Offside Front Tyre has ply or cords exposed (5.2.3 (d) (ii)) DANGEROUS

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive subframe mount (5.3.6 (a) (i))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive subframe mount (5.3.6 (a) (i))

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Tyre slightly damaged/cracking or perishing all four (5.2.3 (d) (ii))

offside parking brake efficiency low

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Nearside Front Anti-roll bar linkage rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Anti-roll bar linkage rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Front wheel bearing rough when rotated (2.5.A.2)

Nearside Rear Suspension component mounting prescribed area is excessively corroded inner sill panel (2.4.A.3)

Offside Front wheel bearing rough when rotated (2.5.A.2)

Offside Rear Suspension component mounting prescribed area is excessively corroded inner sill panel (2.4.A.3)

Nearside Front Anti-roll bar linkage rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Anti-roll bar linkage rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Front Anti-roll bar linkage rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Anti-roll bar linkage rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits possibly because the exhaust is blowing (7.3.D.3)

Exhaust has a major leak of exhaust gases (7.1.2)

Nearside Side repeater not working (1.4.A.2c)

Offside Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Rear rear brake recording little or no effort there was a loud pop when brakes applied hard from the os rear (3.7.B.5a)

Exhaust has a minor leak of exhaust gases (7.1.2)

Front Anti-roll bar linkage rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Inner Front constant velocity joint gaiter deteriorated, but preventing the ingress of dirt (2.5.C.1a)

Oil leak

Rear Brake pad(s) wearing thin (3.5.1g)

Rear Seat belt anchorage prescribed area is corroded but not considered excessive (5.2.6)

Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Rear brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

front disc back plates correded

sill covers fitted

Nearside Rear Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Exhaust has a minor leak of exhaust gases (7.1.2)

Front Anti-roll bar linkage rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Inner Front constant velocity joint gaiter deteriorated, but preventing the ingress of dirt (2.5.C.1a)

Oil leak

Rear Brake pad(s) wearing thin (3.5.1g)

Rear Seat belt anchorage prescribed area is corroded but not considered excessive (5.2.6)

Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Rear brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

front disc back plates correded

sill covers fitted

Engine covers fitted obscuring some components in the engine bay

both front brake disc back plates in poor condition

both front tyres VERY close to legal limit

n/s/f and o/s/f back plates rusty and holed

Nearside Front Windscreen washer provides insufficient washer liquid (8.2.3)

Nearside Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

n/s/f and o/s/f back plates rusty and holed

Front Service brake indicates brake judder (3.7.D.1)

Exhaust has part of the system slightly deteriorated (7.1.1a)

Nearside Front Tie bar/rod rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Tie bar/rod rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Rear coil spring fractured (2.4.C.1a)

Nearside Front Tie bar/rod rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Tie bar/rod rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Front Brake pad(s) insecure (3.5.1g)

Nearside Front brake disc excessively pitted (3.5.1h)

Offside Front brake disc slightly scored (3.5.1h)