2001 Subaru Forester

covers on sills not allowing full inspection, o/s rear sill end rusty not within perscribed area

Exhaust has a minor leak of exhaust gases tail pipe (6.1.2 (a))

Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Rear Shock absorbers insecurely attached bolt loose (5.3.2 (a) (i))

Exhaust has a minor leak of exhaust gases tail pipe (6.1.2 (a))

Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Front Service brake binding but not excessively (1.2.1 (f))

Nearside Rear Fuel pipe damaged side of tank (6.1.3 (c) (ii))

Offside Front Inner Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Offside Rear Inner Vehicle structure is corroded but structural rigidity is not significantly reduced arch (6.1.1 (c) (i))

Rear Prop shaft flexible coupling slightly deteriorated bushs in housing (6.1.7 (d) (i))

Rear Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Nearside Headlamp aim too low (1.8)

Nearside Stop lamp not working (1.2.1b)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Outer Rear Brake pad(s) wearing thin (3.5.1g)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

n/s/r outer brake disc scored

Nearside Front Front constant velocity joint gaiter damaged, but preventing the ingress of dirt (2.5.C.1a)

Nearside Rear Brake pipe slightly corroded (3.6.B.2c)

Offside Rear Brake pipe slightly corroded (3.6.B.2c)

Nearside Rear Brake pipe excessively corroded (3.6.B.2c)

Offside Rear Brake pipe excessively corroded (3.6.B.2c)

Offside Registration plate lamp not working (1.1.C.1d)

Nearside Front Anti-roll bar rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Anti-roll bar rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)