2003 Toyota Land Cruiser

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive Behind fuel tank (5.3.6 (a) (i))

Brake pipe corroded, covered in grease or other material under sealed (1.1.11 (c))

Offside Rear Integral body structure is corroded but structural rigidity is not significantly reduced body mount (6.1.1 (c) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear suspension units undersealed

Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Nearside Rear Anti-roll bar linkage ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Nearside Rear Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced body mount (6.1.1 (c) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength chassis (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength chassis (5.3.6 (a) (i))

Offside Stop lamp(s) not working (4.3.1 (a) (ii))

Brake pipe corroded, covered in grease or other material under sealed (1.1.11 (c))

Headlamp has a product on the lens but not seriously reducing light output both (4.1.4 (b))

Offside Rear Integral body structure is corroded but structural rigidity is not significantly reduced body mount (6.1.1 (c) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear suspension units undersealed

Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Brake pipe corroded, covered in grease or other material all covered in under seal (1.1.11 (c))

Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

under side of vehicle covered in under seal

Exhaust emissions exceed manufacturer's specified limit (8.2.2.2 (a))

Nearside Front Anti-roll bar linkage ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Nearside Rear Lower Suspension component mounting prescribed area excessively corroded significantly reducing structural strength spring mount on axle (5.3.6 (a) (i))

Offside Rear Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced (6.1.1 (c) (i))

Rear Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Brake pipe corroded, covered in grease or other material all covered in under seal (1.1.11 (c))

Nearside Headlamp lens slightly defective (4.1.1 (b) (i))

Offside Headlamp lens slightly defective (4.1.1 (b) (i))

Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

under side of vehicle covered in under seal

Front Suspension component mounting prescribed area is corroded but not considered excessive all front suspension arm mounting points (5.3.6 (a) (i))

Headlamp has a product on the lens but not seriously reducing light output both (4.1.4 (b))

Nearside Front Upper Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Rear Shock absorbers has slight external damage to the casing (5.3.2 (b))

Nearside Rear Upper Suspension spring mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Front Lower Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Offside Front Upper Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Offside Rear Upper Suspension spring mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Rear Brake pad(s) wearing thin both sides (1.1.13 (a) (ii))

Rear Vehicle structure is corroded but structural rigidity is not significantly reduced all chassis (6.1.1 (c) (i))

plastic sill covers fitted

Front Suspension component mounting prescribed area is corroded but not considered excessive all front suspension arm mounting points (5.3.6 (a) (i))

Headlamp has a product on the lens but not seriously reducing light output both (4.1.4 (b))

Nearside Front Upper Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Rear Shock absorbers has slight external damage to the casing (5.3.2 (b))

Nearside Rear Upper Suspension spring mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Front Lower Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Offside Front Upper Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Offside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Rear Upper Suspension spring mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Rear Brake pad(s) wearing thin both sides (1.1.13 (a) (ii))

Rear Vehicle structure is corroded but structural rigidity is not significantly reduced all chassis (6.1.1 (c) (i))

plastic sill covers fitted

Exhaust emissions exceed manufacturer's specified limit (8.2.2.2 (a))

Nearside Front Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced (6.1.1 (c) (i))

Nearside Rear Anti-roll bar attachment bracket/mounting corroded and seriously weakened D bush mounting (5.3.3 (b) (i))

Nearside Rear Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced inner sill (6.1.1 (c) (i))

Nearside Rear Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced sill end cap (6.1.1 (c) (i))

Nearside Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Offside Front Anti-roll bar linkage ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Offside Front Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced (6.1.1 (c) (i))

Offside Rear Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced inner sill (6.1.1 (c) (i))

Offside Rear Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced sill end cap (6.1.1 (c) (i))

Rear fog lamp not working (4.5.1 (a) (ii))

Nearside Rear Anti-roll bar attachment bracket/mounting insecure and impairing directional stability (5.3.3 (a) (ii)) DANGEROUS

Nearside Headlamp lens slightly defective (4.1.1 (b) (i))

Offside Headlamp lens slightly defective (4.1.1 (b) (i))

Offside wiper arm loose

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Towbar slightly corroded within 30cm of towbar mounting (6.1.6 (i) (i))

Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

suspension units and mountings corroded

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Exhaust emissions exceed manufacturer's specified limit (8.2.2.2 (a))

Nearside Front Inner Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Offside Front Inner Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Offside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Stop lamp(s) not working (4.3.1 (a) (ii))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside headlight lense deteriorated /output reduced

Offside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Inner Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Offside Front Lower Anti-roll bar linkage ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Offside Rear Inner Suspension component mounting prescribed area is corroded but not considered excessive sill (5.3.6 (a) (i))

fuel filler metal pipes corroded but not leaking

hand brake has little reserve travel

Nearside Front Inner Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Nearside Front Lower Anti-roll bar linkage ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Nearside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Nearside Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Inner Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Offside Front Lower Anti-roll bar linkage ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Offside Rear Inner Suspension component mounting prescribed area is corroded but not considered excessive sill (5.3.6 (a) (i))

fuel filler metal pipes corroded but not leaking

hand brake has little reserve travel

Central Exhaust has a minor leak of exhaust gases (7.1.2)

Parking brake lever has little reserve travel (3.1.6b)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Nearside Front Anti-roll bar linkage ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.4.G.2)

Nearside Rear Lower Coil spring mounting corroded and seriously weakened (2.4.C.3c)

Offside Front Front position lamp(s) not working (1.1.A.3b)

Offside Registration plate lamp not working (1.1.C.1d)

Central Exhaust has a minor leak of exhaust gases (7.1.2)

Parking brake lever has little reserve travel (3.1.6b)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Nearside Lower Windscreen has damage to the swept area in excess of a 40mm circle outside zone 'A' (8.3.1d)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

offside front inner cv gaiter insecure

rear seats not fitted seat belts not checked

under body/chassis corroded

Nearside Registration plate lamp not illuminating the registration plate (1.1.C.1e)

Offside Registration plate lamp not working (1.1.C.1d)

Rear Vehicle structure has slight corrosion (6.1.A.1)

Rear Vehicle structure has slight corrosion (6.1.A.1)

Service brake is causing the vehicle to swerve to the nearside (3.7.C.2)

Nearside Rear brake caliper leaking (3.6.A.1)

Nearside Front Lower Suspension arm has slight play in a ball joint (2.4.G.2)

Brakes imbalanced across an axle (3.7.B.5b)

Offside rear brake binding (3.7.B.1)

Nearside Front Lower Suspension arm has slight play in a ball joint (2.4.G.2)

Offside Rear Brake pad(s) wearing thin (3.5.1g)

Brakes imbalanced across an axle (3.7.B.5b)

Offside rear brake binding (3.7.B.1)

Front Brake disc(s) worn/pitted

Front Brake pad(s) wearing thin (3.5.1g)

Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Rear Brake pad(s) wearing thin (3.5.1g)

Offside front brake grabbing slightly (3.7.A.2b)

Offside Rear fog lamp not working (1.3.2b)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Front Brake pad(s) wearing thin (3.5.1g)