2012 Toyota Hilux

Nearside Front Inner Sill corroded outside prescribed area

Nearside Rear Towbar component corroded, but not excessively (6.1.6 (a))

Offside Rear Shock absorber dirt cover corroded

Front Near side and off side step brackets corroded

Offside Headlamp was her jet missing

Offside Rear Shock absorber shroud corroded

Nearside Rear Brake hose ferrule excessively corroded One of two failed. Second one is slightly corroded (1.1.12 (f) (i))

Nearside Rear Leaf spring fractured (5.3.1 (b) (i))

Nearside Rear Seat belt anchorage prescribed area strength or continuity significantly reduced Sill (7.1.1 (a) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Web section (5.3.6 (a) (i))

Offside Front Anti-roll bar linkage ball joint excessively worn (5.3.4 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Front most, corroded above spring eye. Near side is slightly corroded in same area (5.3.6 (a) (i))

Brake master cylinder close to minimum mark (1.1.10 (d) (i))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Front Near side and off side step brackets corroded

Nearside Front Lower Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Offside Headlamp has a product on the lens but not seriously reducing light output Also near side but much less so. (4.1.4 (b))

Offside Headlamp was her jet missing

Offside Rear Shock absorber shroud corroded

Parking brake only just met requirements 18%

Power steering fluid level low

Offside Front Headlamp washer jet missing

Nearside Front Lower Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Nearside Rear Leaf spring shackle bracket corroded but not seriously weakened (5.3.1 (b) (i))

Exhaust mounting defective Centre section bracket corroded and broken (6.1.2 (a))

Exhaust mounting defective Centre section bracket corroded and broken (6.1.2 (a))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Nearside Headlamp aim too high (4.1.2 (a))

Offside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Headlamp aim too low (4.1.2 (a))

Nearside Rear Position lamp has a product on the lens or light source which obviously reduces light intensity (4.2.3 (b) (i))

Nearside Rear Stop lamp(s) lens defective which has no effect on emitted light (4.3.1 (b) (i))

Nearside Rear Stop lamp(s) lens defective which has no effect on emitted light (4.3.1 (b) (i))

Nearside Rear Stop lamp(s) lens defective which has no effect on emitted light (4.3.1 (b) (i))

Offside Headlamp not working on dipped beam (4.1.1 (a) (ii))

Nearside Rear Shock absorber has a light misting of oil (2.7.3)

Front registration plate deteriorated (6.3.1d)

Nearside Headlamp aim too high (1.8)

Offside Headlamp aim too high (1.8)

Windscreen washer provides insufficient washer liquid (8.2.3)