2003 Mitsubishi Shogun

Battery insecure but not likely to fall from carrier (4.13 (a) (i))

Brake pipe clips or supports missing, pipe adequately supported both mains (1.1.11 (d) (i))

Integral body structure is corroded but structural rigidity is not significantly reduced crossmember and outriggers (6.1.1 (c) (i))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive outer and inner sill (5.3.6 (a) (i))

Offside Front Brake master cylinder/servo mounting prescribed area is corroded but not considered excessive inner arch/engine bay (1.1.21 (e) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive inner sill (5.3.6 (a) (i))

Offside Rear Upper Suspension arm pin or bush worn but not resulting in excessive movement front bush on arm (5.3.4 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Lower Suspension arm pin or bush worn but not resulting in excessive movement both trailing arm rear bushes (5.3.4 (a) (i))

Sub-frame corroded but not seriously weakened both (5.3.3 (b) (i))

Suspension arm corroded but not seriously weakened all (5.3.3 (b) (i))

Vehicle structure is corroded but structural rigidity is not significantly reduced and covered in underseal (6.1.1 (c) (i))

all underbody covered in underseal

Exhaust emissions exceed manufacturer's specified limit (8.2.2.2 (a))

Nearside Headlamp has a product on the lens so that the light output is severely reduced (4.1.4 (b))

Nearside Rear Anti-roll bar linkage ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Nearside Rear Brake hose ferrule excessively corroded (1.1.12 (f) (i))

Nearside Rear Service brake excessively binding (1.2.1 (f))

Offside Front Anti-roll bar linkage ball joint excessively worn (5.3.4 (a) (i))

Offside Front Service brake excessively binding (1.2.1 (f))

Offside Headlamp has a product on the lens so that the light output is severely reduced (4.1.4 (b))

Offside Rear Brake hose ferrule excessively corroded (1.1.12 (f) (i))

Offside Rear Service brake excessively binding (1.2.1 (f))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill (5.3.6 (a) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Central Rear Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Battery insecure but not likely to fall from carrier (4.13 (a) (i))

Brake pipe clips or supports missing, pipe adequately supported both mains (1.1.11 (d) (i))

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Integral body structure is corroded but structural rigidity is not significantly reduced crossmember and outriggers (6.1.1 (c) (i))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive outer and inner sill (5.3.6 (a) (i))

Offside Front Brake master cylinder/servo mounting prescribed area is corroded but not considered excessive inner arch/engine bay (1.1.21 (e) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive inner sill (5.3.6 (a) (i))

Offside Rear Upper Suspension arm pin or bush worn but not resulting in excessive movement front bush on arm (5.3.4 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Rear Lower Suspension arm pin or bush worn but not resulting in excessive movement both trailing arm rear bushes (5.3.4 (a) (i))

Sub-frame corroded but not seriously weakened both (5.3.3 (b) (i))

Suspension arm corroded but not seriously weakened all (5.3.3 (b) (i))

Vehicle structure is corroded but structural rigidity is not significantly reduced and covered in underseal (6.1.1 (c) (i))

all underbody covered in underseal

All underbody, suspension etc covered in underseal

Battery insecure but not likely to fall from carrier (4.13 (a) (i))

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Front Headlamp has a product on the lens but not seriously reducing light output both (4.1.4 (b))

Front Lower Suspension arm ball joint has slight play both (5.3.4 (a) (i))

Front Suspension arm corroded but not seriously weakened all (5.3.3 (b) (i))

Integral body structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Offside Front Anti-roll bar ball joint has slight play (5.3.4 (a) (i))

Offside Front Brake master cylinder/servo mounting prescribed area is corroded but not considered excessive inner wheel arch (1.1.21 (e) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (1.4.2 (a) (i))

Battery insecure but not likely to fall from carrier (4.13 (a) (i))

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Front Lower Suspension arm ball joint has slight play BOTH (5.3.4 (a) (i))

Front Sub-frame corroded but not seriously weakened and all arms (5.3.3 (b) (i))

Nearside Front Inner Suspension component mounting prescribed area is corroded but not considered excessive Wheel Arch (5.3.6 (a) (i))

Offside Front Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Offside Front Service brake binding but not excessively (1.2.1 (f))

Offside Integral body structure is corroded but structural rigidity is not significantly reduced Inner sill (6.1.1 (c) (i))

Offside side step rusty & insecure

Rear Coil spring corroded BOTH (5.3.1 (b) (i))

Rear Sub-frame corroded but not seriously weakened and all arms (5.3.3 (b) (i))

Nearside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Rear Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Central Exhaust has a major leak of exhaust gases (7.1.2)

Front Brake pad(s) wearing thin (3.5.1g)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Parking brake lever has little reserve travel (3.1.6b)

Nearside Front Upper Suspension arm has slight play in a ball joint (2.4.G.2)

Offside Front Upper Suspension arm has slight play in a ball joint (2.4.G.2)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Registration plate lamp not working (1.1.C.1d)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside front brake binding (3.7.B.1)

Exhaust has part of the system slightly deteriorated (7.1.1a)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

under tray fitted to vehicle some parts not checked properly

Nearside Rear Trailing arm has slight play in a pin/bush (2.4.G.2)

Offside Rear Trailing arm has slight play in a pin/bush (2.4.G.2)

advise new tyre to o/s rear keep check on n/s rear tyre