2004 Honda Anf

Rear Wheel bearing has slight play (5.1.3 (a) (i))

Front Headlamp aim too low (4.1.2 (a))

Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Stop lamp not working (4.3.1 (a) (ii))

Headlamp light intensity reduced (4.1.4 (a))

Front tyre under inflated

Headlamp light intensity reduced (4.1.4 (a))

Rear Tyre worn close to the legal limit (5.2.3 (e))

Horn not working (7.7 (a) (ii))

Front tyre under inflated

Headlamp light intensity reduced (4.1.4 (a))

Rear Tyre worn close to the legal limit (5.2.3 (e))

Motorcycle structure is corroded but structural rigidity is not significantly reduced swingarm (6.1.1 (c) (i))

Motorcycle structure slightly corroded frame (6.1.1a)

Motorcycle structure slightly corroded swingarm (6.1.1a)

fuel tank corroded

Front Brake disc(s) slightly worn (3.2.A1l)

Front Brake pad(s) close to minimum limit 2 mm (3.2.A1f(i))

Fuel tank slightly corroded

Motorcycle structure slightly corroded (6.1.1a)

Motorcycle structure slightly corroded swingarm (6.1.1a)

Nearside Rear spring corroded but not seriously weakened (2.4A1b(ii))

Offside Rear spring corroded but not seriously weakened (2.4A1b(ii))

Front Brake disc(s) slightly worn (3.2.A1l)

Rear Brake lining(s) close to minimum limit (3.2.A1f(i))

Front position lamp does not illuminate immediately when switched on (1.1.3a)

Rear Roller brake test indicates a binding brake (3.3.A1a)

Front Brake disc(s) slightly worn (3.2.A1l)

Front Stop lamp does not illuminate immediately a brake applies (1.3.1a)

Rear Brake component has restricted free movement and operation is likely to be impeded (3.2.A1h)

Rear Stop lamp does not illuminate immediately a brake applies (1.3.1a)

Rear position lamp does not illuminate immediately when it is switched on (1.1.3a)

Front Brake pad(s) close to minimum limit (3.2.A1f(i))

Drive chain slightly loose (6.2.1d)

Exhaust is leaking but is not excessively noisey (7.1.1b)

Front Roller brake test indicates a slightly juddering brake (3.3.A1b)

Front Brake pad(s) less than 1.5 mm thick (3.2.A1f(i))

Front Tyre has a tear caused by separation or partial failure of its structure (4.1.2a(ii))

Drive chain worn but not considered excessive (6.2.1e)

Front Brake pad(s) close to minimum limit (3.2.A1f(i))

Front Brake pad(s) less than 1.5 mm thick (3.2.A1f(i))

Rear position lamp adversely affected by the operation of another lamp (1.1.3b)

Exhaust is leaking and excessively noisey (7.1.1b)

Brake pedal cannot be released smoothly (3.1.3d)

Front Floor brake test indicates a binding brake (3.3.C2c)

Front Brake pad(s) close to minimum limit (3.2.A1f(i))