2003 Mazda RX-8

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust carbon monoxide content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Exhaust carbon monoxide content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Nearside Rear Headlamp levelling device inoperative ride height arm on switch broken (4.1.5 (a))

Offside Rear Suspension component mounting prescribed area is corroded to the extent that control of the vehicle is likely to be adversely affected inner sill area (5.3.6 (a) (ii)) DANGEROUS

Electronic stability control warning lamp indicates a fault (7.12 (e))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Exhaust carbon monoxide content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Nearside Front Outer Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Nearside Rear Outer Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Offside Rear Outer Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Front Service brake binding but not excessively (1.2.1 (f))

Nearside Front Headlamp lens slightly defective (4.1.1 (b) (i))

Nearside Rear Inner Suspension component mounting prescribed area is corroded but not considered excessive sill (5.3.6 (a) (i))

Offside Front Headlamp lens slightly defective (4.1.1 (b) (i))

Offside Front Tyre slightly damaged/cracking or perishing (5.2.3 (d) (i))

Offside Rear Inner Suspension component mounting prescribed area is corroded but not considered excessive sill (5.3.6 (a) (i))

car very rusty underneath

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Exhaust emissions carbon monoxide content at idle excessive (7.3.D.4)

Exhaust emissions hydrocarbon content after 2nd fast idle excessive (7.3.D.3)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

Engine covers fitted obscuring some components in the engine bay

Engine lamp lit

Offside Rear Rear position lamp(s) has light sources not illuminating, but not more than 50% (1.1.A.3b)

Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Rear Brake pad(s) wearing thin (3.5.1g)

Service brake: service brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Under-trays fitted obscuring some underside components

Underside of vehicle corroded

Offside Front Tyre worn close to the legal limit (4.1.E.1)

both rear tyres tread cracked

off side headlamp aim slightly high

Exhaust tailpipe not capable of allowing the emission probe to be inserted (7.3.D.1)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside rear brake binding (3.7.B.1)

Rear Exhaust has a major leak of exhaust gases (7.1.2)

Nearside rear brake fluctuating, but not excessively (3.7.B.3)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Service brake: service brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

both rear tyres tread cracked

off side headlamp aim slightly high

Engine covers fitted obscuring some components in the engine bay

Items removed from driver's view prior to test

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Under-trays fitted obscuring some underside components

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

both wiper blades torn on edges

exhaust centre rear mounting broken away from pipe.

exhaust system front heatshield insecure

sill outer trim covers and inner wheel arch covers fitted.

Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

Engine covers fitted obscuring some components in the engine bay

Front Brake pad(s) wearing thin (3.5.1g)

Items removed from driver's view prior to test

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Under-trays fitted obscuring some underside components

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

exhaust heatshield insecure at front

sill covers fitted

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside rear brake binding (3.7.B.1)

Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Rear Stop lamp not working (1.2.1b)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Anti-roll bar linkage has excessive play in a ball joint (2.4.G.2)