2005 Toyota Land Cruiser

Offside Rear fog lamp missing (4.5.1 (a) (ii))

Nearside Rear Upper Shock Absorber mount corroded but not likely to be unattached

Nearside Rear Upper Suspension spring mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Supplementary restraint system warning lamp indicates a fault (7.1.6 (a))

Nearside Rear Upper Shock Absorber mount corroded but not likely to be unattached

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Supplementary restraint system warning lamp indicates a fault (7.1.6 (a))

Nearside Rear Suspension component mounting prescribed area is corroded to the extent that control of the vehicle is likely to be adversely affected Front trailing arm mounting (5.3.6 (a) (ii)) DANGEROUS

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Front Registration plate does not conform to the specified requirements (0.1 (d))

Nearside Front Lower Anti-roll bar linkage ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Nearside Rear Direction indicator not working (4.4.1 (a) (ii))

Offside Front Lower Anti-roll bar linkage ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Front Brakes imbalanced across an axle Nearside low (3.7.B.5b)

Nearside Front Upper Front suspension ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt (2.4.G.2)

Offside Front Upper Front suspension ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt (2.4.G.2)

Parking brake: efficiency below requirements (3.7.B.7)

Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

Front Brake pad(s) wearing thin (3.5.1g)

Rear shock absorbers in poor condition

Nearside Inner Front constant velocity joint gaiter damaged to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Rear fog lamp not working (1.3.2b)

Brake pipe slightly corroded (3.6.B.2c)

Items removed from driver's view prior to test

Nearside Rear Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

both rear seats removed unable to carry out seat belt check

Nearside Inner Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

Offside Registration plate lamp not working (1.1.C.1d)

Parking brake: efficiency below requirements (3.7.B.7) DANGEROUS

Brake pipe slightly corroded (3.6.B.2c)

Items removed from driver's view prior to test

Nearside Outer Front Brake pad(s) wearing thin (3.5.1g)

Nearside Rear Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

both rear seats removed unable to carry out seat belt check

Nearside Rear Direction indicators not working (1.4.A.2c)

Exhaust has a major leak of exhaust gases (7.1.2)

Nearside Rear Direction indicators incorrect colour (1.4.A.2f)

Nearside Stop lamp not working (1.2.1b) DANGEROUS

Offside Stop lamp not working (1.2.1b) DANGEROUS

Exhaust has a minor leak of exhaust gases (7.1.2)

Offside Outer Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Rear fog lamp not working (1.3.2b)

Exhaust has a minor leak of exhaust gases (7.1.2)

engine oil leak

note trip milage entered on test

Nearside Rear position lamp(s) not working (1.1.A.3b)

Offside rear brake recording little or no effort (3.7.B.5a)

Parking brake lever has no reserve travel (3.1.6b)

Windscreen has damage to the swept area in excess of a 40mm circle outside zone 'A' (8.3.1d)

Parking brake: efficiency below requirements (3.7.B.7) DANGEROUS

engine oil leak

rear pads appear low need checking with wheels removed

Front Brake pad(s) wearing thin (3.5.1g)

Rear Brake pad(s) wearing thin (3.5.1g)

offside front tyre worn on inner edge