2006 Mazda 3

Central Rear Exhaust has a major leak of exhaust gases (6.1.2 (a))

Emissions not tested (8.2.1.2 (d))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Front Driver's view of the road through the swept area of the windscreen significantly affected by an obstruction air fresheners etc from mirror (3.1 (a) (ii))

Nearside Front Headlamp not working on dipped beam (4.1.1 (a) (ii))

Nearside Front Upper Anti-roll bar linkage ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Offside Front Lower Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Front Brake pad(s) wearing thin very low pad (1.1.13 (a) (ii))

Front Oil leak, but not excessive (8.4.1 (a) (i))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Rear Suspension arm attachment bracket/mounting corroded but its strength is not seriously reduced (5.3.3 (b) (i))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Shock absorbers has slight external damage to the casing (5.3.2 (b))

Offside Rear Suspension arm attachment bracket/mounting corroded but its strength is not seriously reduced (5.3.3 (b) (i))

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Exhaust mounting defective (6.1.2 (a))

Exhaust silencer slightly loose (8.1.1 (b) (i))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Rear Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Rear Suspension arm pin or bush worn but not resulting in excessive movement trailing arm bush (5.3.4 (a) (i))

Offside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Shock absorbers has slight external damage to the casing (5.3.2 (b))

Offside Rear Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Offside Rear rear lamp has slight damage

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

exhaust heat shield insecure

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Nearside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Offside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (5.2.3 (d) (i))

Offside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Rear Anti-roll bar linkage ball joint excessively worn (5.3.4 (a) (i))

Offside Rear Anti-roll bar linkage ball joint excessively worn (5.3.4 (a) (i))

Offside Rear Suspension arm pin or bush excessively worn trailing arm bush (5.3.4 (a) (i))

Offside Stop lamp(s) not working (4.3.1 (a) (ii))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Nearside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Exhaust mounting defective (6.1.2 (a))

Exhaust silencer slightly loose (8.1.1 (b) (i))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Rear Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Rear Suspension arm pin or bush worn but not resulting in excessive movement trailing arm bush (5.3.4 (a) (i))

Offside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Shock absorbers has slight external damage to the casing (5.3.2 (b))

Offside Rear Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Offside Rear rear lamp has slight damage

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

exhaust heat shield insecure

general under body corrosion

Electronic stability control warning lamp indicates a fault (7.12 (e))

Nearside Front Lower Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Nearside Front Position lamp not working (4.2.1 (a))

Offside Front Lower Suspension arm ball joint excessively worn (5.3.4 (a) (i))

general under body corrosion

Nearside Rear Brake pad(s) wearing thin (3.5.1g)

Offside Rear Brake pad(s) wearing thin (3.5.1g)

general under body corrosion

nearside and offside front tyres worn on edges

rear exhaust mounts corroded

Nearside Front position lamp(s) not working (1.1.A.3b)

Nearside Headlamp not working on dipped beam (1.7.5a)

Nearside Rear Brake pad(s) wearing thin (3.5.1g)

Offside Rear Brake pad(s) wearing thin (3.5.1g)

general under body corrosion

nearside and offside front tyres worn on edges

rear exhaust mounts corroded

Offside Front Lower Bonded suspension unit deteriorated but can function as intended (2.4.F.3)

Offside Rear tyre perished

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Engine covers fitted obscuring some components in the engine bay

Under-trays fitted obscuring some underside components

Items removed from driver's view prior to test

Electronic stability system warning lamp indicates a fault (3.4.1c)

Items removed from driver's view prior to test

traction light on

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Anti-lock braking system warning lamp indicates an ABS fault (3.4.1c)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Front Brake pad(s) wearing thin (3.5.1g)