2015 Mazda Bongo

Anti-lock braking system warning lamp indicates an ABS fault (1.6 (b))

Front Windscreen washer not working (3.5 (a))

Nearside Front Headlamp aim projected beam image is obviously incorrect due to lens going milky (4.1.2 (c))

Nearside Inner Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced sill front to back holed (6.1.1 (c) (i))

Nearside Rear Outer Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill holed (5.3.6 (a) (i))

Offside Front Headlamp aim projected beam image is obviously incorrect plus lens needs polished out (4.1.2 (c))

Offside Front Headlamp not working on dipped beam (4.1.1 (a) (ii))

Offside Inner Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced sill front to back holed (6.1.1 (c) (i))

Offside Rear Outer Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill holed (5.3.6 (a) (i))

Offside Rear Rear fog lamp not working (4.5.1 (a) (ii))

both rear Reversing lamp full water

Front bumper cable tie on osf

Offside Rear water in light unit

headlamps just passed aim test due to outer lens going milky

Nearside Body component likely to become detached diesel heater exhaust pipe snapped and insecure plus fouling road wheel on nearside rear (6.2.1 (a) (ii)) DANGEROUS

Nearside Rear Nail in tyre ()

Offside Rear Nail in tyre ()

headlamps just passed aim test due to outer lens going milky

front bumper damaged

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Offside Front Position lamp not working (4.2.1 (a) (ii))

front bumper damaged

Oil leak, but not excessive (8.4.1 (a) (i))

front bumper has slight damage and grill slighly loose

Nearside Front Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting inner sill holed within 30cm of wishbone & subframe mounting points (6.2.2 (d) (i))

Nearside Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting sill holed centre within 30cm of pasenger seat and pasenger seatbelt mounting point . (6.2.2 (d) (i))

Nearside Rear Shock absorbers has a serious fluid leak (5.3.2 (b))

Offside Front Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting inner sill holed within 30cm of wishbone & subframe mounting points (6.2.2 (d) (i))

Offside Front Position lamp not working side light bulb (4.2.1 (a) (ii))

Offside Rear Rear fog lamp missing (4.5.1 (a) (ii))

Front bumper has slight damage and grill slightly loose

Oil leak, but not excessive (8.4.1 (a) (i))

Oil leak, but not excessive gearbox oil leak (8.4.1 (a) (i))

Oil leak, but not excessive oil leak round engine bay (8.4.1 (a) (i))

Engine MIL inoperative or indicates a malfunction em light on (8.2.1.2 (h))

Front Headlamp light intensity severely reduced front headlamps have surface corrosion (4.1.4 (a))

Nearside Rear Shock absorbers has a serious fluid leak (5.3.2 (b))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Front Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Front Bumper likely to become detached front bumper loose (6.1.4 (a) (ii)) DANGEROUS

Rear Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Front Service brake binding but not excessively (1.2.1 (f))

Oil leak, but not excessive gearbox oil leak (8.4.1 (a) (i))

Oil leak, but not excessive oil leak round engine bay (8.4.1 (a) (i))

Windscreen wiper blade defective front wipers smearing (3.4 (b) (i))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Shock absorbers light misting of oil or has limited damping effect Both rear (5.3.2 (b))

Nearside Front Bumper damaged and likely to cause injury when grazed or contacted Front bumper damaged but nearside has sharp edge (6.1.4 (a) (i))

Nearside Front Suspension arm ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Offside Front Suspension arm ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Rear fog lamp not working (4.5.1 (a) (ii))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Shock absorbers light misting of oil or has limited damping effect Both rear (5.3.2 (b))

Front bumper has some damage

Nearside Rear light lens broken

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Rear Shock absorbers light misting of oil or has limited damping effect both rears have slight weap (5.3.2 (b))

Electrical wiring insecure and connectors likely to become disconnected fuse box under dash is loose and hanging out (4.11 (a) (ii))

Nearside Front Road wheel fixing missing (5.2.1 (a) (i))

Nearside Rear Road wheel fixing missing (5.2.1 (a) (i))

Offside Front Headlamp insecure (4.1.1 (c))

Offside Front Road wheel fixing missing (5.2.1 (a) (i))

Offside Rear Road wheel fixing missing (5.2.1 (a) (i))

Front bumper has some damage

Headlamp lens slightly defective both head lamps giving poor aim patten (4.1.1 (b) (i))

Nearside Rear light lens broken

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Rear Shock absorbers light misting of oil or has limited damping effect both rears have slight weap (5.3.2 (b))

Nearside Rear Shock absorber has a light misting of oil (2.7.3)

Offside Rear Shock absorber has a light misting of oil (2.7.3)

Nearside Front Suspension arm ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt (2.4.G.2)

Offside Front Suspension arm ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt (2.4.G.2)

Rear fog lamp missing (1.3.2a)