2012 Land Rover Discovery

Nearside Front Wheel bearing has slight play (5.1.3 (a) (i))

Offside Rear parking brake cable bracket worn.

both rear back plates corroding.

Nearside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement inner bush. (5.3.4 (a) (i))

Offside Front Brake hose has slight corrosion to ferrule (1.1.12 (f) (i))

Offside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement inner bush (5.3.4 (a) (i))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear parking brake cable retaining bracket worn.

both rear brake disc back plates corroding.

Central Rear Prop shaft bearing excessively worn (6.1.7 (b) (i))

Nearside Front Headlamp aim too high (4.1.2 (a))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Nearside Rear Anti-roll bar linkage ball joint excessively worn (5.3.4 (a) (i))

Nearside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement inner bush. (5.3.4 (a) (i))

Offside Front Brake hose has slight corrosion to ferrule (1.1.12 (f) (i))

Offside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement inner bush (5.3.4 (a) (i))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

both rear brake disc back plates corroding.

Nearside Rear Lower Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Rear Lower Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Rear Upper Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Offside Rear Lower Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Offside Rear Lower Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Upper Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Vehicle structure is corroded but structural rigidity is not significantly reduced chassis (6.1.1 (c) (i))

Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Nearside Front Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Nearside Rear Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Nearside Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Rear Lower Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Rear Lower Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Rear Upper Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Offside Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Rear Lower Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Offside Rear Lower Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Upper Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Vehicle structure is corroded but structural rigidity is not significantly reduced chassis (6.1.1 (c) (i))

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Brake performance not tested due to brake fluid leak (1.2.1 (g))

Nearside Rear Brake pipe excessively corroded from hose (1.1.11 (c))

Nearside Rear Brake pipe excessively corroded to hose (1.1.11 (c))

Offside Rear Brake pipe excessively corroded from hose (1.1.11 (c))

Offside Rear Brake pipe excessively corroded to hose (1.1.11 (c))

Rear Brake pipe leaking on a hydraulic braking system (1.1.11 (b) (ii)) DANGEROUS

Nearside Brake pipe slightly corroded Front to rear (3.6.B.2c)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Brake pipe slightly corroded Front to rear (3.6.B.2c)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Headlamp not working on main beam (1.7.5a)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Under-trays fitted obscuring some underside components