2003 Daihatsu Yrv

Front Headlamp has a product on the lens but not seriously reducing light output Both (4.1.4 (b))

Nearside Front Track rod end ball joint has slight play (2.1.3 (b) (i))

Offside Front Inner Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Offside Front Scratches on windscreen

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Sill panel holed (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Sill panel holed (5.3.6 (a) (i))

Rear Registration plate lamp inoperative in the case of a single lamp or all lamps Both (4.7.1 (b) (ii))

Offside Front Scratches in windscreen

Front Headlamp has a product on the lens but not seriously reducing light output Both (4.1.4 (b))

Emissions not tested (8.2.1.2 (d))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Front Bumper insecure (6.1.4 (a) (i))

Nearside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill, wheel arch (5.3.6 (a) (i))

Offside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill, wheel arch (5.3.6 (a) (i))

Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Windscreen washer provides insufficient washer liquid (3.5 (a))

Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Exhaust carbon monoxide content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Stop lamp(s) all not working (4.3.1 (a) (iii)) DANGEROUS

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Nearside Front Lower Suspension arm ball joint dust cover deteriorated, but preventing the ingress of dirt (2.4.G.2)

Offside Front Lower Suspension arm ball joint dust cover deteriorated, but preventing the ingress of dirt (2.4.G.2)

Nearside Front Headlamp has a product on the lens so that the light output is severely reduced (1.7.5a)

Nearside Front Lower Suspension arm ball joint dust cover deteriorated, but preventing the ingress of dirt (2.4.G.2)

Offside Front Headlamp has a product on the light source so that the light output is severely reduced (1.7.5a)

Offside Front Lower Suspension arm ball joint dust cover deteriorated, but preventing the ingress of dirt (2.4.G.2)

Nearside Front Tyre tread pattern not visible over the whole tread area when minimum depth required is 1.0mm (4.1.E.2a)

Offside Front Tyre tread pattern not visible over the whole tread area when minimum depth required is 1.0mm (4.1.E.2a)

Nearside Headlamp aim too high (1.8)

Offside Headlamp aim too low (1.8)

Centre Exhaust has a major leak of exhaust gases (7.1.2)

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Rear Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Offside Front position lamp(s) not working (1.1.A.3b)

Stop lamp not working (1.2.1b)

inner boot on nsf drive shaft damp

oil dipstick broken

Nearside Headlamp damaged but light output not reduced (1.7.5a)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

cover fitted to steering wheel insecure

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)