2010 Honda CBF125

Drive chain worn but not considered excessive Oil dry (6.1.7 (c) (i))

Exhaust slightly loose (6.1.2 (a))

Front Slight bind brake

Rear Motorcycle structure is corroded but structural rigidity is not significantly reduced Frame (6.1.1 (c) (i))

Rear Tyre worn close to the legal limit (5.2.3 (e))

Wheel alignment slightly misaligned Adjusted incorrectly (2.4 (a))

Rear reflector missing (4.8.2 (a) (ii))

Steering operation linkage fouling when handlebars turned from lock to lock (2.1.4 (a))

Drive chain worn but not considered excessive Oil dry (6.1.7 (c) (i))

Exhaust slightly loose (6.1.2 (a))

Front Slight bind brake

Rear Motorcycle structure is corroded but structural rigidity is not significantly reduced Frame (6.1.1 (c) (i))

Rear Tyre worn close to the legal limit (5.2.3 (e))

Wheel alignment slightly misaligned Adjusted incorrectly (2.4 (a))

Front Indicator tell tale inoperative (4.9.1 (a) (i))

Front Fork yoke insecure nut missing (2.2.2 (d) (i))

Nearside Drive chain excessively loose (6.1.7 (c) (i))

Offside Brake pedal is bent and the brake cannot be readily applied (1.1.2 (d))

Rear Tyre tread depth is below minimum requirements of 1.0mm (5.2.3 (e)) DANGEROUS

Stop lamp does not illuminate by the operation of both brake controls (4.3.2 (a) (iii)) DANGEROUS

Front Indicator tell tale inoperative (4.9.1 (a) (i))

Front Tyre worn close to the legal limit (5.2.3 (e))

Nearside Drive chain worn but not considered excessive (6.1.7 (c) (i))

Front Tyre worn close to the legal limit (5.2.3 (e))

Front Tyre worn close to the legal limit (5.2.3 (e))

Motorcycle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Front Tyre worn close to the legal limit (5.2.3 (e))

Headlamp aim too far to the left (4.1.2 (a))

Motorcycle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Drive chain worn to excess (6.2.1e)

Rear Roller brake test indicates a binding brake (3.3.A1a)

Drive chain slightly loose (6.2.1d)

Front Brake pad(s) less than 1.5 mm thick (3.2.A1f(i))