2005 Mazda 5

Nearside Inner Integral body structure is corroded but structural rigidity is not significantly reduced sill (6.1.1 (c) (i))

Offside Inner Integral body structure is corroded but structural rigidity is not significantly reduced sill (6.1.1 (c) (i))

Offside Rear Tyre worn close to legal limit/worn on edge on 1.6mm (5.2.3 (e))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust carbon monoxide content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Exhaust carbon monoxide content at idle exceeds default limits (8.2.1.2 (b))

Exhaust hydrocarbon content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Nearside Front Inner Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Nearside Headlamp aim too high (4.1.2 (a))

Offside Headlamp aim too high (4.1.2 (a))

Exhaust emits blue smoke during acceleration (8.2.1.2 (g))

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

inner sills rusty

Offside Front Inner Suspension arm pin or bush excessively worn (5.3.4 (a) (i))

Rear Exhaust has a major leak of exhaust gases (6.1.2 (a))

inner sills rusty

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Rear Brake pad(s) wearing thin (3.5.1g)

Nearside Rear coil spring broken (2.4.C.1a)

Nearside Stop lamp not working (1.2.1b)

Offside Front Tyre has ply or cords exposed (4.1.D.1b)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Rear Brake pad(s) wearing thin (3.5.1g)

Rear Suspension component mounting prescribed area is corroded but not considered excessive N/S & O/S (2.4.A.3)

Unable to inspect third row of seat belts

Nearside Inner Front constant velocity joint gaiter damaged to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Offside Front Anti-roll bar linkage ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt (2.4.G.2)

Offside Front position lamp(s) not working (1.1.A.3b)

Offside Headlamp aim beam image obviously incorrect (1.8.A.1b)

Rear Suspension component mounting prescribed area is corroded but not considered excessive N/S & O/S (2.4.A.3)

Unable to inspect third row of seat belts

windscreen has damage outside of the swept area

Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Rear Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

both front tyres worn on edges

Nearside Front Suspension arm rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Offside Front Suspension arm rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Nearside Rear Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

both front tyres worn on edges

front tyres worn inner edge