2005 Subaru Forester

Nearside Front Lower Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Offside Front Lower Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Exhaust carbon monoxide content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Front Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Rear Upper Suspension component mounting prescribed area is corroded but not considered excessive inner wing shock mounting (5.3.6 (a) (i))

Brake pedal anti-slip provision worn smooth (1.1.2 (c))

Front Suspension arm ball joint dust cover no longer prevents the ingress of dirt Lower front outer both sides (5.3.4 (b) (ii))

Offside Rear Sub-frame corroded and seriously weakened (5.3.3 (b) (i))

Brake lever has insufficient reserve travel Handbrake (1.1.2 (a))

Emissions unable to be completed Exhaust blowing (8.2.1.2 (d))

Offside Front Headlamp aim unable to be tested (4.1.2 (b))

Offside Front Headlamp not working on dipped beam (4.1.1 (a) (ii))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Central Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Central Exhaust mounting defective (6.1.2 (a))

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Rear Sub-frame corroded and seriously weakened (5.3.3 (b) (i))

Rear Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Emissions not tested (8.2.1.2 (d))

Exhaust emissions likely to be affected by an exhaust leak (8.2.1.1 (b))

rear chassis has slight surface corrosion

rear suspension components has slight surface corrosion

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

headlights slightly faded

rear chassis has slight surface corrosion

rear suspension components has slight surface corrosion

Rear Brake pad(s) wearing thin (3.5.1g)

o/s rear tyre 2.2mm Remainder 3mm

Offside Front Tyre worn close to the legal limit (4.1.E.1)

nearside front tyre won on outer edge

both front tyres wearing on edges