2007 Subaru Forester

Front Headlamp has a product on the lens but not seriously reducing light output both front headlights (4.1.4 (b))

Front Windscreen wiper blade defective (3.4 (b) (i))

Nearside Front Inner Track rod end ball joint has slight play (2.1.3 (b) (i))

Nearside Rear Tyre worn close to legal limit/worn on edge worn on inner edge (5.2.3 (e))

Offside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Rear Anti-roll bar linkage ball joint has slight play both rear droplinks (5.3.4 (a) (i))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Play in steering rack inner joint(s) ()

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Nearside Headlamp aim unable to be tested (4.1.2 (b))

Nearside Headlamp not working on dipped beam (4.1.1 (a) (ii))

Offside Rear fog lamp not working (4.5.1 (a) (ii))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Offside Rear Suspension component mounting prescribed area is corroded to the extent that control of the vehicle is likely to be adversely affected (5.3.6 (a) (ii)) DANGEROUS

Lower Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Nearside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Nearside Position lamp not working (4.2.1 (a) (ii))

Nearside Rear Anti-roll bar pin or bush excessively worn (5.3.4 (a) (i))

Offside Front Anti-roll bar pin or bush excessively worn (5.3.4 (a) (i))

Offside Position lamp not working (4.2.1 (a) (ii))

Offside Rear Anti-roll bar pin or bush excessively worn (5.3.4 (a) (i))

Lower Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Brake hydraulic reservoir close to minimum mark (1.1.10 (d) (i))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Inner Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Inner Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Inner sill has hole within 30cm of suspension component (5.3.6 (a) (i))

Nearside Headlamp aim projected beam image is obviously incorrect bulb fitted incorrectly (4.1.2 (c))

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Nearside Front Headlamp not working on dipped beam (1.7.5a)

Offside Front Headlamp aim too high (1.8)

Offside Front position lamp(s) not working (1.1.A.3b)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Towbar component slightly corroded (6.6.1)

Vehicle structure slightly corroded within 30cm of towbar mounting (6.6.6)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Nail in nearside rear tyre

Nearside Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Spare tyre defective

Nail in nearside rear tyre