2009 Ford Ka

Parking brake efficiency below requirements (1.4.2 (a) (i))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Rear axle corroded

Nearside Front Lower Suspension arm pin or bush excessively worn (5.3.4 (a) (i))

Nearside Front Shock absorbers has a serious fluid leak (5.3.2 (b))

Offside Front Lower Suspension arm pin or bush excessively worn (5.3.4 (a) (i))

Offside Front Shock absorbers has a serious fluid leak (5.3.2 (b))

Windscreen washer provides insufficient washer liquid (3.5 (a))

Front Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (1.2.1 (b) (i))

Front Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Rear axle corroded

Offside Rear Service brake binding but not excessively (1.2.1 (f))

Nearside Front Outer Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Nail in tyre

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Axle corroded

Rear Coil spring corroded Both (5.3.1 (b) (i))

Windscreen wiper does not clear the windscreen effectively Both (3.4 (b) (ii))

Nearside Front Outer Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Nail in tyre

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Axle corroded

Rear Coil spring corroded Both (5.3.1 (b) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear underside of vehicle corroed

Suspension arm pin or bush worn but not resulting in excessive movement Both lower arm rear bushes (5.3.4 (a) (i))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Rear Tyre worn close to legal limit/worn on edge 3mm (5.2.3 (e))

Offside Rear Tyre worn close to legal limit/worn on edge 1.6mm (5.2.3 (e))

Rear Coil spring corroded both (5.3.1 (b) (i))

Rear axle corroded

Offside Rear Tyre slightly damaged/cracking or perishing cracks in tread area (5.2.3 (d) (ii))

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)