2012 Peugeot Partner

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Front Tyre worn close to legal limit/worn on edge edges (5.2.3 (e))

Nearside Rear Tyre worn close to legal limit/worn on edge edges (5.2.3 (e))

Offside Front Anti-roll bar linkage ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Outer Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Offside Rear Tyre worn close to legal limit/worn on edge edges (5.2.3 (e))

Offside Track rod end ball joint has slight play (2.1.3 (b) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

offside door mirror cover damaged

Front Suspension arm pin or bush worn but not resulting in excessive movement both sides (5.3.4 (a) (i))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Rear Coil spring corroded both sides (5.3.1 (b) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Rear Suspension arm pin or bush worn but not resulting in excessive movement both sides (5.3.4 (a) (i))

Rear Suspension component mounting prescribed area is corroded but not considered excessive both sides (5.3.6 (a) (i))

Rear Suspension spring mounting prescribed area is corroded but not considered excessive both sides (5.3.6 (a) (i))

Nearside Front Coil spring fractured or broken (5.3.1 (b) (i))

Nearside Front Outer Track rod end ball joint has excessive play (2.1.3 (b) (i))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Offside Front Coil spring fractured or broken (5.3.1 (b) (i))

Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Nearside Rear Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Front Suspension arm pin or bush worn but not resulting in excessive movement both sides (5.3.4 (a) (i))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Rear Coil spring corroded both sides (5.3.1 (b) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Rear Suspension arm pin or bush worn but not resulting in excessive movement both sides (5.3.4 (a) (i))

Rear Suspension component mounting prescribed area is corroded but not considered excessive both sides (5.3.6 (a) (i))

Rear Suspension spring mounting prescribed area is corroded but not considered excessive both sides (5.3.6 (a) (i))

Offside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Rear bump stops deteriorated

Nearside Rear Stop lamp(s) not working (4.3.1 (a) (ii))

Offside Rear Stop lamp(s) not working (4.3.1 (a) (ii))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Rear bump stops deteriorated

Nearside Brake cable damaged but not to excess (1.1.15 (a))

Nearside Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Offside Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

spare tyre less than 1.6mm

Nearside Front Position lamp not working (4.2.1 (a))

Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Nearside Brake cable damaged but not to excess (1.1.15 (a))

Nearside Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Offside Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

spare tyre less than 1.6mm

Offside Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

driveshaft seal leaking

Nearside Rear Registration plate lamp not working (1.1.C.1d)

Offside Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

driveshaft seal leaking

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Registration plate lamp not working both (1.1.C.1d)