2006 Rieju RS2

Clutch lever positioned so it cannot be readily operated Cable and adjuster not located in lever bracket (6.2.7 (b))

Drive chain worn to excess (6.1.7 (c) (i))

Headlamp aim projected beam image obviously incorrect (4.1.2 (c))

Rear Brake hose excessively twisted Also getting crushed by exhaust when rear suspension under load (1.1.12 (b) (ii))

Steering headbearing has excessive wear or free play (2.2.2 (f) (i))

Rear Tyre has a tear caused by separation or partial failure of its structure (5.2.3 (d) (ii)) DANGEROUS

Riders seat insecure (6.2.5 (a) (ii)) DANGEROUS

Front Brake fluid below minimum mark (1.1.10 (d) (i))

Front Brake lever is bent but brake can still be readily applied (1.1.2 (d))

Front Shock absorber has a reduced damping effect Also has fork gaiters/socks fitted so possible seals leaking (5.3.2 (b))

Rear Wheel bearing has slight play (5.1.3 (a) (i))

Registration plate deteriorated but not likely to be misread (0.1 (b))

Wheel alignment slightly misaligned (2.4 (a))

Front Stop lamp does not illuminate by the operation of both brake controls (4.3.2 (a) (iii))

Chain guard missing ()

Drive chain slightly loose (6.2.1d)

Front Brake fluid reservoir fluid level low (3.2.B1d)

Gearchange lever close to sidestand and may be difficult to select gears wearing large boots.

No indicator tell-tale but front indicators visible from riding position.

No speedometer/odometer fitted.

Front wheel bearings are excessively rough (2.3.5b)

Steering headbearing has excessive free play (2.2.2)

Steering movement excessively stiff with the weight on the lower bearing (2.2.1a)

Rear Rear wheel spindle securing nut(s) loose (2.4.A.2b)

Front Tyre tread not clearly visible (4.1.3(i))