2010 Nissan Pixo

Headlamp lens slightly defective both (4.1.1 (b) (i))

Nearside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement rear bush (5.3.4 (a) (i))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Inner Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Rear Lower Suspension arm corroded but not seriously weakened trailing arms both sides (5.3.3 (b) (i))

Rear Shock absorbers has slight external damage to the casing both (5.3.2 (b))

Front Brake disc worn, pitted or scored, but not seriously weakened both (1.1.14 (a) (ii))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Front Position lamp not working (4.2.1 (a) (ii))

Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Front Brake disc worn, pitted or scored, but not seriously weakened both (1.1.14 (a) (ii))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Rear Shock absorbers has slight external damage to the casing (5.3.2 (b))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength axle by trailing arm mount (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength axle by shock absorber mount (5.3.6 (a) (i))

Nearside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Rear Shock absorbers has slight external damage to the casing (5.3.2 (b))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive axle traling arm mount (5.3.6 (a) (i))

Horn not working (7.7 (a) (ii))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength axle trailing arm mount (5.3.6 (a) (i))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive axle traling arm mount (5.3.6 (a) (i))

Offside Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Nearside Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Horn not working (1.6.2a)

both rear tyres side wall perishing

both wiper blades poor

Both front wipers and rear wiper split

Nearside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Offside Front wheel bearing rough when rotated (2.5.A.2)

Both front wipers and rear wiper split

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside front tyre 2-3mm & bald edges.

Wipers smearing screen slightly.