2012 Mazda 2

Nearside Rear Suspension component corroded but not seriously weakened Inner sill (5.3.3 (b) (i))

Offside Rear Inner Suspension component corroded but not seriously weakened Sill (5.3.3 (b) (i))

Rear Suspension component corroded but not seriously weakened Axle (5.3.3 (b) (i))

Rear Brake hose has slight corrosion to ferrule (1.1.12 (f) (i))

rear axle rusty

vehicle rusty underneath

Nearside Front Tyre has a tear, caused by separation or partial failure of its structure (5.2.3 (d) (ii)) DANGEROUS

Offside Front Tyre has a tear, caused by separation or partial failure of its structure (5.2.3 (d) (ii)) DANGEROUS

Nearside Front Windscreen wiper blade defective (3.4 (b) (i))

Rear Brake hose has slight corrosion to ferrule (1.1.12 (f) (i))

rear axle rusty

vehicle rusty underneath

Nearside Rear Tyre slightly damaged (5.2.3 (d) (ii))

Offside driveshaft seal damp

Rear Brake hose has slight corrosion to ferrule (1.1.12 (f) (i))

rusty underneath

Play in steering rack inner joint(s)

Offside Rear Coil spring worn (5.3.1 (b) (i))

Offside Front Anti-roll bar pin or bush excessively worn D bush (5.3.4 (a) (i))

Offside Front Drive shaft bearing excessively worn central bearing (6.1.7 (b) (i))

Offside Front Lower Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Nearside Front Anti-roll bar pin or bush worn but not resulting in excessive movement D bush (5.3.4 (a) (i))

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Rear Nail in tyre

Nearside Front Tyre tread depth below requirements of 1.6mm 195/45r16 (4.1.E.1)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear Nail in tyre

Offside Front Nail in tyre

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Nearside Windscreen wiper does not clear the windscreen effectively 14' (8.2.2)

Offside Windscreen wiper does not clear the windscreen effectively 24' (8.2.2)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)