2013 Seat Mii

Central Exhaust has a major leak of exhaust gases (6.1.2 (a))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Offside Rear Tyre has a tear, caused by separation or partial failure of its structure (5.2.3 (d) (ii)) DANGEROUS

Nearside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Nearside Front Tyre worn close to legal limit/worn on edge 3.0mm (5.2.3 (e))

Child Seat fitted not allowing full inspection of adult belt ()

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Rear Tyre slightly damaged/cracking or perishing both sides (5.2.3 (d) (ii))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust carbon monoxide content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Exhaust carbon monoxide content at idle exceeds manufacturer's specified limits (8.2.1.2 (b))

Exhaust hydrocarbon content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Supplementary restraint system warning lamp indicates a fault (7.1.6 (a))

Windscreen wiper does not clear the windscreen effectively both (3.4 (b) (ii))

Child Seat fitted not allowing full inspection of adult belt ()

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Rear Tyre slightly damaged/cracking or perishing both sides (5.2.3 (d) (ii))

both rear tyres slightly perished and cracked

Fuel cap/sealing device ineffective (6.1.3 (b) (i))

both rear tyres slightly perished and cracked

Nearside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Offside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Offside Front Headlamp aim too low (4.1.2 (a))

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Tyres slightly perished. Dated 2013.

Windscreen has damage to an area in excess of a 10mm circle within zone 'A' (8.3.1a)

rear brake application uneven (3.7.B.2)