2003 Suzuki DRZ400

Front Brake binding but not excessively (1.2.1 (f))

Stop lamp only working from front control - no wiring or switch fitted to rear pass and advise

Stop lamp does not illuminate by the operation of both brake controls (4.3.2 (a) (iii)) DANGEROUS

Front Position lamp not working side light (4.2.1 (a))

Headlamp aim projected beam image obviously incorrect (4.1.2 (c))

Rear reflector missing (4.8.2 (a) (ii))

Registration plate lamp missing in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Stop lamp does not illuminate by the operation of both brake controls not working from rear brake pedal (4.3.2 (a) (iii)) DANGEROUS

Chain guard missing ()

Drive chain slightly loose (6.1.7 (c) (i))

Drive chain sprocket worn, but not excessively (6.1.7 (c) (i))

Drive chain worn but not considered excessive (6.1.7 (c) (i))

Front Brake disc fractured (1.1.14 (a) (ii))

Rear Brake pad(s) incorrectly mounted (1.1.13 (c))

Rear Brake pad(s) less than 1.0 mm thick (1.1.13 (a))

Centre Rear Motorcycle structure slightly insecure Rear mudgaurd loose and could fall off (6.1.1c)

DAYTIME USE ONLY lights masked at time of test

Exhaust noisy (7.1.2)

Exhaust noisy (7.1.2)

Rear reflector on motorcycle missing (1.4.1)

Registration plate with character(s) which are not the correct height (6.3.4a)

Registration plate with character(s) which are not the correct width (6.3.4a)

Exhaust noisy (7.1.2)

Drive chain excessively loose (6.2.1d)

Drive chain worn to excess (6.2.1e)

Front Floor brake test indicates a binding brake (3.3.C2c)

Headlamp at least one does not illuminate on main beam (1.2.2a(ii))

Horn control defective (1.7.2a)

Horn not working (1.7.3a)

Rear Tyre not fitted in accordance with side wall instruction/s (4.1.2e)

Rear Upper Rear suspension bush has excessive free play (2.4.A2a(i))

Rear Wheel spoke excessively loose (4.2.1b)

Rear reflector on motorcycle missing (1.4.1)

Registration plate characters incorrectly spaced (6.3.4a)

Registration plate characters laid out in an incorrect format (6.3.4f)

Stop lamp does not illuminate immediately a brake applies (1.3.1a)

Front Brake pad(s) close to minimum limit (3.2.A1f(i))

Front wheel bearings have slight free play (2.3.5b)

gear change lever loose

no directional indicators or switch fitted at time of test

no headlamp switch fitted to vehicle

spedo insecure

Exhaust noisy (7.1.2)

No lights fitted at time of test