2011 Peugeot 107

Front Upper Macpherson strut pin or bush worn but not resulting in excessive movement both sides rough operation (5.3.4 (a) (i))

Front subframe heavily undersealed

Nearside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Front Wheel bearing slightly noisy (5.1.3 (b) (i))

Offside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Outer Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Rear Suspension arm corroded but not seriously weakened axle corroded and undersealed (5.3.3 (b) (i))

Rear Suspension component mounting prescribed area is corroded but not considered excessive both sides (5.3.6 (a) (i))

Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

clutch release bearing noise??

Nearside Rear Service brake excessively binding (1.2.1 (f))

Offside Front Obligatory mirror insecure (3.3 (b) (ii))

Rear Brakes imbalanced across an axle 38% (1.2.1 (b) (i))

Offside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Front Upper Macpherson strut pin or bush worn but not resulting in excessive movement both sides rough operation (5.3.4 (a) (i))

Front subframe heavily undersealed

Nearside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Front Wheel bearing slightly noisy (5.1.3 (b) (i))

Offside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Outer Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Offside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Rear Tyre worn close to legal limit/worn on edge 2.6mm (5.2.3 (e))

Rear Suspension arm corroded but not seriously weakened axle corroded and undersealed (5.3.3 (b) (i))

Rear Suspension component mounting prescribed area is corroded but not considered excessive both sides (5.3.6 (a) (i))

Rear Tyre slightly damaged/cracking or perishing both sides (5.2.3 (d) (ii))

Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

clutch release bearing noise??

Hazard warning switch faulty (4.4.2 (a) (i))

Offside Front Obligatory mirror slightly damaged (3.3 (b) (i))

Offside Front Tyre worn close to legal limit/worn on edge 2mm (5.2.3 (e))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Suspension component mounting repair covered in underseal (5.3.6 (a) (i))

Offside Rear Tyre has a cut but not deep enough to reach the ply or cords (5.2.3 (d) (i))

Rear Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. 28% (1.2.1 (b) (i))

Rear Suspension arm corroded but not seriously weakened axle heavily corroded both sides (5.3.3 (b) (i))

Rear Suspension component mounting prescribed area is corroded but not considered excessive both sides (5.3.6 (a) (i))

Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Nearside Rear Parking brake inoperative on one side (1.4.1 (a))

Offside Front Anti-roll bar linkage pin or bush excessively worn (5.3.4 (a) (i))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Hazard warning switch faulty (4.4.2 (a) (i))

Nearside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Obligatory mirror slightly damaged (3.3 (b) (i))

Offside Front Tyre worn close to legal limit/worn on edge 2mm (5.2.3 (e))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Tyre has a cut but not deep enough to reach the ply or cords (5.2.3 (d) (i))

Rear Suspension arm corroded but not seriously weakened axle heavily corroded both sides (5.3.3 (b) (i))

Rear Suspension component mounting prescribed area is corroded but not considered excessive both sides (5.3.6 (a) (i))

Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Nearside Parking brake inoperative on one side (1.4.1 (a))

Offside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Corrosion to exhauast hangers

Nearside Rear Service brake binding but not excessively (1.2.1 (f))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a) DANGEROUS

Offside Headlamp not working on dipped beam (1.7.5a)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nail in offside rear tyre

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

offside rear tyre cracking on sidewall and between tread