2012 Kia Rio

Nearside Front Anti-roll bar linkage ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Nearside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Offside Front Anti-roll bar linkage ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Offside Front Service brake binding but not excessively (1.2.1 (f))

Offside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Rear Exhaust mounting defective (6.1.2 (a))

Steering rack has slight free play detected at steering wheel (2.3 (a) (i))

Nearside Front Anti-roll bar linkage ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Nearside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Offside Front Anti-roll bar linkage ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Offside Front Service brake binding but not excessively (1.2.1 (f))

Offside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Rear Exhaust mounting defective (6.1.2 (a))

Steering rack has slight free play detected at steering wheel (2.3 (a) (i))

Windscreen washer provides insufficient washer liquid (3.5 (a))

Nearside Rear Tyre worn close to legal limit/worn on edge outer edge (5.2.3 (e))

Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

front pads starting to get low

front reg plate deteriorated

tailbox joint corroded

Nearside Rear Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Nearside Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Rear Tyre worn close to legal limit/worn on edge outer edge (5.2.3 (e))

Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

front pads starting to get low

tailbox joint corroded

Front Registration plate deteriorated but not likely to be misread damaged (0.1 (b))

slight corrosion rear springs cups on axle.

Nearside Front Suspension arm ball joint has slight play (5.3.4 (a) (i))

Rear Lower Suspension spring mounting prescribed area is corroded but not considered excessive both sides (5.3.6 (a) (i))

Nearside Front Outer Tyre has a bulge, caused by separation or partial failure of its structure sidewall (5.2.3 (d) (ii)) DANGEROUS

Nearside Front Suspension arm ball joint has slight play (5.3.4 (a) (i))

Rear Lower Suspension spring mounting prescribed area is corroded but not considered excessive both sides (5.3.6 (a) (i))

Nearside Rear tyre low and feathering inner edge

front discs lip on edges

Nearside Front Suspension arm ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Offside Front Suspension arm ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

front discs lip on edges

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Tyre has a cut but not deep enough to reach the ply or cords (5.2.3 (d) (i))

Cut on outside wall of O/S front tyre, not showing cord

Centre Front items removed from driver's view prior to test