2003 Mazda 6

Headlamp levelling device inoperative (4.1.5 (a))

Nearside Headlamp aim too low (4.1.2 (a))

Nearside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill / jack point. (5.3.6 (a) (i))

Nearside Rear Lower Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill (5.3.6 (a) (i))

Offside Headlamp aim too low (4.1.2 (a))

Offside Rear Lower Suspension component mounting prescribed area excessively corroded significantly reducing structural strength floor section. (5.3.6 (a) (i))

Offside Rear Lower Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner sill / jack point. (5.3.6 (a) (i))

Offside Rear Lower Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill (5.3.6 (a) (i))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

front & rear subframes heavily corroded.

slight play in front lower ball joints.

Offside Front Headlamp not working on dipped beam (1.7.5a)

Front Front position lamp(s) not working both (1.1.A.3b)

Registration plate lamp not working (1.1.C.1d)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

nearside rear tyre has wear to outer edge

rear exhaust mount broken but still supported

Front Brake pad(s) wearing thin (3.5.1g)

Front Tyre worn close to the legal limit (4.1.E.1)

Nearside rear tyre starting to go out of shape.

Nearside rear tyre starting to go out of shape.

Offside Rear Tyre has a lump, caused by separation or partial failure of its structure (4.1.D.1b)