2006 Toyota Aygo

Nearside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Nearside Rear Wheel bearing slightly noisy (5.1.3 (b) (i))

Offside Front Wheel bearing has slight play (5.1.3 (a) (i))

Nearside Front Anti-roll bar linkage pin or bush excessively worn (5.3.4 (a) (i))

Nearside Front Outer Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (5.2.3 (d) (i))

Nearside Front Wheel bearing has excessive play (5.1.3 (a) (i))

Nearside Inner Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced (6.1.1 (c) (i))

Nearside Rear Stop lamp(s) not working (4.3.1 (a) (ii))

Offside Front Anti-roll bar linkage pin or bush excessively worn (5.3.4 (a) (i))

Offside Inner Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced (6.1.1 (c) (i))

Offside Rear Vehicle structure inadequately repaired such that structural rigidity is significantly reduced (6.1.1 (d) (i))

Offside Rear Vehicle structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting (6.2.2 (d) (i))

Parking brake lever has excessive movement indicating incorrect adjustment (1.1.6 (c))

Nearside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Nearside Rear Wheel bearing slightly noisy (5.1.3 (b) (i))

Offside Front Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Offside Front Wheel bearing has slight play (5.1.3 (a) (i))

Nearside Front Inner Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Front Outer Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Offside Front Inner Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Nearside Front Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Nearside Rear Inner Brake pipe excessively corroded (1.1.11 (c))

Offside Front Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Rear Inner Brake pipe excessively corroded (1.1.11 (c))

Offside Rear Parking brake inoperative on one side (1.4.1 (a))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Supplementary restraint system warning lamp indicates a fault (7.1.6 (a))

Nearside Front Inner Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Front Outer Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Nearside Rear Service brake requirements only just met. It would appear that the braking system requires adjustment or repair (1.2.1 (c))

Offside Front Inner Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Service brake requirements only just met. It would appear that the braking system requires adjustment or repair (1.2.1 (c))

Nearside Front Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Offside Front Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Rear Suspension arm corroded but not seriously weakened trailing arm both sides (5.3.3 (b) (i))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Offside Front Headlamp insecure (4.1.1 (c))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill (5.3.6 (a) (i))

Nearside Front Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Offside Front Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Rear Suspension arm corroded but not seriously weakened trailing arm both sides (5.3.3 (b) (i))

Nearside Rear Brake hose has slight corrosion to ferrule (1.1.12 (f) (i))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill (5.3.6 (a) (i))

Offside Rear Brake hose ferrule excessively corroded (1.1.12 (f) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner sill (5.3.6 (a) (i))

Nearside Rear Brake hose has slight corrosion to ferrule (1.1.12 (f) (i))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Front Lower Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Nearside Rear Brake hose has slight corrosion to ferrule (1.1.12 (f) (i))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive inner sill to chassis (5.3.6 (a) (i))

Offside Front Lower Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Offside Rear Brake hose has slight corrosion to ferrule (1.1.12 (f) (i))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive inner sill to chassis (5.3.6 (a) (i))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Front Registration plate inscription illegible (0.1 (b))

Nearside Front Lower Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Nearside Rear Brake hose has slight corrosion to ferrule (1.1.12 (f) (i))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive inner sill to chassis (5.3.6 (a) (i))

Offside Front Lower Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Offside Rear Brake hose has slight corrosion to ferrule (1.1.12 (f) (i))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive inner sill to chassis (5.3.6 (a) (i))

Nearside Rear Brake hose has slight corrosion to ferrule (1.1.12 (f) (i))

Offside Rear Brake hose has slight corrosion to ferrule (1.1.12 (f) (i))

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Brake pipe corroded, covered in grease or other material centre (1.1.11 (c))

Nearside Rear Service brake binding but not excessively (1.2.1 (f))

Offside Brake pipe corroded, covered in grease or other material centre (1.1.11 (c))

Offside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement rear bush (5.3.4 (a) (i))

Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

rear axle corroded

near side and off side rear brake pipes becoming rusty

Offside Rear Lower Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

near side and off side rear brake pipes becoming rusty

near side and off side rear brake pipes becoming rusty

near side rear tyre close to limet

slight exhaust blow from manifold

Offside Front position lamp(s) not working (1.1.A.3b)

Offside Front Inner Brake pad(s) wearing thin (3.5.1g)

Offside Front Inner Brake pad(s) wearing thin (3.5.1g)

Offside Registration plate lamp not working (1.1.C.1d)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Registration plate lamp not working (1.1.C.1d)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Registration plate lamp not working (1.1.C.1d)

Offside Headlamp aim too low (1.8)

Tyre worn close to the legal limit (4.1.E.1)