2008 Peugeot 107

Brake lever has insufficient reserve travel (1.1.2 (a))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Nearside Rear Brake drum back plate insecure corroded (1.1.14 (d))

Rear Exhaust has a major leak of exhaust gases (6.1.2 (a))

Rear Axle insecure such that stability is impaired (5.1.1 (b) (ii)) DANGEROUS

Rear Suspension component mounting prescribed area is corroded to the extent that control of the vehicle is likely to be adversely affected axle (5.3.6 (a) (ii)) DANGEROUS

Fluid leak, but not excessive coolant pump (8.4.1 (a) (i))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Front Exhaust has a minor leak of exhaust gases Manifold flange corroded (6.1.2 (a))

Nearside Rear brake back plate corroded

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Suspension component corroded but not seriously weakened axle (5.3.3 (b) (i))

Nearside Rear brake shoe back plate corroded

Nearside Rear Tyre has a tear, caused by separation or partial failure of its structure perished to cord (5.2.3 (d) (ii)) DANGEROUS

Nearside Rear brake shoe back plate corroded

Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement Both front (5.3.4 (a) (i))

Front Both front lower arm ball joint boots perishing

Oil leak, but not excessive Gearbox Offside (8.4.1 (a) (i))

Rear Tyre slightly damaged/cracking or perishing Both rears perishing/cracking (5.2.3 (d) (ii))

Nearside Rear wheel bearing rough when rotated (2.6.1)

Offside Front position lamp(s) not working (1.1.A.3b)

Front Lower suspension arms dust covers deteriorated

Nearside Rear brake back plate corroded

rear brake fluctuating, but not excessively (3.7.B.3)

rear parking (secondary) brake imbalance requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.6b)

Nearside Front Tyre has a tear, caused by separation or partial failure of its structure inner side wall (4.1.D.1b)

Nearside Registration plate lamp not working (1.1.C.1d)

Offside rear brake binding (3.7.B.1)

unable to fully inspect the front brake pads

unable to fully test the offside rear wheel bearing

Offside Rear Registration plate lamp not working (1.1.C.1d)

Front Brake pad(s) wearing thin (3.5.1g)

Front Brake pad(s) wearing thin (3.5.1g)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Headlamp aim too low (1.8)