2008 Toyota Aygo

Brake pipe corroded, covered in grease or other material Front to Rear, at offside rear (1.1.11 (c))

Front Exhaust mounting defective (6.1.2 (a))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Coil spring corroded Nearside and Offside (5.3.1 (b) (i))

Rear Suspension component corroded but not seriously weakened Axle beam (5.3.3 (b) (i))

Registration plate deteriorated but not likely to be misread Front and Rear (0.1 (b))

Nearside Front Headlamp aim unable to be tested lens defective (4.1.2 (b))

Front Oil leak, but not excessive (8.4.1 (a) (i))

Nearside Front Inner Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Rear Coil spring corroded both (5.3.1 (b) (i))

centre exhaust section holder broken

rear exhaust rubber holder perished

Front Headlamp aim unable to be tested both (4.1.2 (b))

Front Headlamp lens seriously defective both (polishing req) (4.1.1 (b) (ii))

Offside Front Tyre has ply or cords exposed 155/65/14 (5.2.3 (d) (ii)) DANGEROUS

Front Oil leak, but not excessive (8.4.1 (a) (i))

Nearside Front Inner Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Rear Coil spring corroded both (5.3.1 (b) (i))

centre exhaust section holder broken

rear exhaust rubber holder perished

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Registration plate insecure but not likely to fall off (0.1 (a))

Exhaust has a major leak of exhaust gases (6.1.2 (a))

Nearside Front Lower Suspension arm pin or bush excessively worn REAR BUSH BONDING (5.3.4 (a) (i))

Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Rear Registration plate insecure but not likely to fall off (0.1 (a))

Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Nearside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Offside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Rear Tyre worn close to legal limit/worn on edge on limit (5.2.3 (e))

Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Front Brake pad(s) wearing thin (3.5.1g)

Nearside Rear Registration plate lamp not working (1.1.C.1d)

Front Brake pad(s) wearing thin (3.5.1g)

cut in outer sidewall of nearside front tyre. no cords exposed