2002 Subaru Forester

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Nearside Front Service brake excessively binding (1.2.1 (f))

Nearside Rear Upper Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Strut top area has excessive corrosion (5.3.6 (a) (i))

Offside Rear Upper Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Strut top area has excessive corrosion (5.3.6 (a) (i))

Central Exhaust has a minor leak of exhaust gases Cat to rear silencer exhaust pipe corroded, blowing (6.1.2 (a))

Nearside Rear Upper Anti-roll bar linkage pin or bush worn but not resulting in excessive movement Bush worn (5.3.4 (a) (i))

Offside Front Position lamp light intensity obviously reduced (4.2.3 (a) (i))

Offside Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Offside rear brake pipes have slight corrosion

Front Tyre worn close to legal limit/worn on edge both front tyres 2.5mm and worn on inner edge. (5.2.3 (e))

Rear Suspension component mounting prescribed area is corroded but not considered excessive Rear subframe (axle) corroding, offside worst. (5.3.6 (a) (i))

Rear Suspension component mounting prescribed area is corroded but not considered excessive macpherson strut top mounting area corroding both dides. (5.3.6 (a) (i))

Registration plate lamp not working (1.1.C.1d)

Offside Inner Front constant velocity joint gaiter damaged to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Nearside Front position lamp(s) not working (1.1.A.3b)

Nearside Inner Front constant velocity joint gaiter damaged, but preventing the ingress of dirt (2.5.C.1a)

Brake pipe slightly corroded os rear hose to wheel cylinder (3.6.B.2c)

Exhaust system heavilly corroded and very weak.

Exhaust system rusted and weakened, Silencer protector peeling.

Front registration plate deteriorated but not likely to be misread (6.3.1d)

Rear Anti-roll bar linkage rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Rear Exhaust has part of the system slightly deteriorated (7.1.1a)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Rear Exhaust has part of the system slightly deteriorated (7.1.1a)

Front brake discs worn

Offside and nearside front tyres worn on inner edges