2005 Fiat Doblo

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Nearside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (5.2.3 (d) (i))

Offside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Offside Rear Inner Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced (6.1.1 (c) (i))

Offside Rear Outer Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced (6.1.1 (c) (i))

Nearside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Front Exhaust has a minor leak of exhaust gases flexi (6.1.2 (a))

Gearbox mounting defective ()

Nearside Front Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Nearside Rear Inner Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Nearside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Offside Front Inner Vehicle structure is corroded but structural rigidity is not significantly reduced wing area (6.1.1 (c) (i))

Offside Front Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Vehicles internal headlight adjuster altered to recheck lights ()

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

Nearside Rear Inner Suspension component mounting prescribed area is corroded but not considered excessive sill (5.3.6 (a) (i))

Nearside Rear Wheel bearing has slight play (5.1.3 (a) (i))

Nearside Rear Wheel bearing slightly noisy (5.1.3 (b) (i))

Offside Rear Inner Suspension component mounting prescribed area is corroded but not considered excessive sill (5.3.6 (a) (i))

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

Nearside Rear Inner Suspension component mounting prescribed area is corroded but not considered excessive sill (5.3.6 (a) (i))

Nearside Rear Wheel bearing has slight play (5.1.3 (a) (i))

Nearside Rear Wheel bearing slightly noisy (5.1.3 (b) (i))

Nearside Stop lamp(s) not working (4.3.1 (a) (ii))

Offside Rear Inner Suspension component mounting prescribed area is corroded but not considered excessive sill (5.3.6 (a) (i))

Registration plate lamp does not illuminate simultaneously with the position lamps n/s & o/s (4.7.2 (a))

Nearside Rear Rear wheel bearing has slight play (2.6.2)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Nearside Rear Upper Shock absorber has an excessively worn bush (2.7.4)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Nearside Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Front Suspension arm rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)