2007 Mazda 6

general corrosion to underside and sills

headlamp lenses not perfect as some deterioration is on the inside of the lense

Exhaust emissions test not completed because smoke levels are significantly in excess of the specified limit values (8.2.2.2 (f))

Nearside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Nearside Rear Anti-roll bar linkage ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Offside Rear Anti-roll bar linkage ball joint dust cover severely deteriorated (5.3.4 (b) (i))

general corrosion to underside and sills

General corrosion to underside of vehicle and suspension

Nearside Headlamp lens slightly defective (4.1.1 (b) (i))

Offside Headlamp lens slightly defective (4.1.1 (b) (i))

Exhaust emissions exceed manufacturer's specified limit (8.2.2.2 (a))

General corrosion to underside of vehicle and suspension

Nearside Headlamp lens slightly defective (4.1.1 (b) (i))

Offside Headlamp lens slightly defective (4.1.1 (b) (i))

slight blow at centre of exhaust

Nearside Front Brakes imbalanced across an axle binding 33% (1.2.1 (b) (i))

Nearside Front Suspension component ball joint dust cover no longer prevents the ingress of dirt forward arm (5.3.4 (b) (ii))

Offside Front Suspension component ball joint dust cover no longer prevents the ingress of dirt forward arm (5.3.4 (b) (ii))

Offside Front Suspension component ball joint dust cover no longer prevents the ingress of dirt rear arm (5.3.4 (b) (ii))

slight blow at centre of exhaust

Nearside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e))

Offside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e))

Offside Headlamp aim too far to the right (1.8)

Exhaust has a minor leak of exhaust gases centre box join (7.1.2)

Suspension arm ball joint dust cover deteriorated, but preventing the ingress of dirt all (2.4.G.2)

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

Registration plate lamp not working (1.1.C.1d)