2009 Mercedes-benz Vito

Engine MIL inoperative or indicates a malfunction (8.2.2.2 (g))

Nearside Front Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Engine MIL inoperative or indicates a malfunction (8.2.2.2 (g))

Offside Front Headlamp aim too low (4.1.2 (a))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Parking brake lever has excessive movement indicating incorrect adjustment (1.1.6 (c))

Rear fog lamp not working (4.5.1 (a) (ii))

Windscreen washer not working (3.5 (a))

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Nearside Front Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Exhaust mounting defective (6.1.2 (a))

Nearside Front Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Nearside Rear Brake pipe excessively corroded (1.1.11 (c))

Offside Front Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Rear Brake pipe excessively corroded (1.1.11 (c))

Offside Rear Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced (6.1.1 (c) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Windscreen washer not working Both front. (3.5 (a))

Brake disc worn, pitted or scored, but not seriously weakened Both rear (1.1.14 (a) (ii))

Exhaust mounting defective (6.1.2 (a))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive cross member (5.3.6 (a) (i))

Front Exhaust system insecure (6.1.2 (a))

Nearside Front Anti-roll bar linkage ball joint excessively worn (5.3.4 (a) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Exhaust fumes causing a danger to health of persons on board rear exhaust section missing (6.1.2 (b) (ii)) DANGEROUS

Offside Front Service brake binding but not excessively (1.2.1 (f))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive cross member (5.3.6 (a) (i))

Nearside Front Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Offside Front Anti-roll bar linkage ball joint excessively worn (5.3.4 (a) (i))

Parking brake lever has excessive movement indicating incorrect adjustment (1.1.6 (c))

Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) DANGEROUS

damage to n/side rear tyre wall

Brakes imbalanced across an axle (3.7.B.5b)

Offside Front Front position lamp(s) not working (1.1.A.3b)

Supplementary Restraint System warning lamp indicates a fault (5.4.2)

damage to n/side rear tyre wall

front bumper insecure

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Front brake disc in such a condition that it is seriously weakened (3.5.1i)

Supplementary Restraint System warning lamp indicates a fault (5.4.2)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Centre Stop lamp remains on when the brakes are released (1.2.1e)

Nearside Stop lamp remains on when the brakes are released (1.2.1e)

Offside Stop lamp remains on when the brakes are released (1.2.1e)