2002 Saab 9-3

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Front Lower Suspension arm ball joint has slight play (5.3.4 (a) (i))

Nearside Front Obligatory mirror slightly damaged (3.3 (b) (i))

Nearside Front Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Side repeater incorrect colour (1.4.A.2f)

Offside Rear Upper Suspension component mounting prescribed area is excessively corroded shock absorber mounting point (2.4.A.3)

Nearside Front Tyre has a bulge, caused by separation or partial failure of its structure (4.1.D.1b) DANGEROUS

Engine covers fitted obscuring some components in the engine bay

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Front registration plate deteriorated but not likely to be misread (6.3.1d)

Rear Brake hose has slight corrosion to ferrules (3.6.B.4e)

Rear coil spring corroded (2.4.C.1b)

Under-trays fitted obscuring some underside components

engine management light on

offside rear tyre wearing on inner edge (not within measured area)

rear exhaust heat shield insecure

Front registration plate deteriorated but not likely to be misread (6.3.1d)

Nearside Rear Brake pad(s) wearing thin (3.5.1g)

coil spring corroded (2.4.C.1b)

nearside rear tyre worn on inner edge (not measured area) Advise replacement

Nearside Front Tyre has a bulge, caused by separation or partial failure of its structure (4.1.D.1b)

Front registration plate deteriorated but not likely to be misread (6.3.1d)

Nearside Rear Brake pad(s) wearing thin (3.5.1g)

coil spring corroded (2.4.C.1b)

nearside rear tyre worn on inner edge (not measured area) Advise replacement

Brake hose has slight corrosion to ferrules (3.6.B.4e)

Offside Rear Rear wheel bearing has slight play (2.6.2)

Tyre worn close to the legal limit (4.1.E.1)

Nearside Front position lamp(s) not working (1.1.A.3b)

Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)